INDUSTRIAL WIRELESS AUTOMATION©2014 OleumTech Corporation. All rights reserved. BreeZ is a registered trademark of OleumTech Corporation. Speci�cations, design, and product descriptions subject to change without notice. Document ID: 67-1002-001e

19762 Pauling, Foothill Ranch, CA 92610Toll-Free (866) 508-8586Phone: (949) 305-9009

Fax: (949) 305-9010Sales@OleumTech.comwww.OleumTech.com

INDUSTRIAL WIRELESS AUTOMATION

PLACE

POSTAGE

HERE

Mail To:

WIRELESS OILFIELD AUTOMATION

CONTROL PANEL∙ RS232 or RS485 Serial Interface with Modbus Master / Slave Function∙ Point-to-Multipoint Networking with End Nodes (Transmitter & I/O Modules)∙ Peer-to-Peer Networking with Other Gateways (Data Sharing & Control)∙ Onboard I/O & I/O Expandable

WELLHEAD∙ Tubing / Casing / Surface / Flowline Pressure∙ Arrival Sensor∙ Valve Control∙ Chemical Pump∙ Plunger Lift

COMPRESSOR∙ Pressure∙ Temperature∙ On / O� Status∙ Panel Data (Modbus)

PRODUCTION TANKS∙ Continuous Level Product / Interface / Temperature∙ Magnetostrictive / Hydrostatic / Resistive∙ High Level Alarm: Top or Side

FLARE STACK∙ Flare Monitoring∙ Temperature∙ Thermocouple

CHEMICAL TANK∙ Level

ADDITIONAL APPLICATIONS∙ Cathodic Protection Monitoring

SEPARATOR∙ Flow∙ High-Level Alarm∙ Pressure∙ Temperature

WIRELESS MULTI I/O∙ Analog Inputs 0-5 V / 0-10 V / 4-20 mA∙ Digital Inputs and Outputs∙ Modbus Master

OleumTech.com ©2014 OleumTech Corporation. All rights reserved.

900 MHz or 2.4 GHz, Point-to-Point, Connect to Gateway

Connect to Base Unit Wireless Gateway

Analog OutputModule WM3000-001

· 4x Analog Outputs 1-5 V (3-Wire)/4-20 mA (2-Wire) Selectable Modes,12-Bit ADC

· 12-24 VDC Power Input

Digital I/O Module WM3000-003

· 8x Programmable Digital Channels· 1 A Sink Current for Open-Drain Outputs· Configurable Debounce Filter· 6-24 VDC Power Input

Wireless Multi-I/O ModuleWM5000-002

· 4x Analog Inputs 0-5 V,0-10 V, or 4-20 mA Selectable Modes, 24-Bit ADC

· 4x Programmable Digital Channels· 9-30 VDC Power Input· RS485 I/O Expansion Port (RJ-45)

WIRELESS I/O EXPANSION MODULES

WIRED I/O EXPANSION MODULES

900 MHz or 2.4 GHz, Point-to-Multipoint, Peer-to-Peer

Base UnitWM2000-002

· RS232 or RS485 Serial Interface (Modbus Master / Slave Function)

· 4x Analog Inputs 0-5 V· 2x Digital Inputs + 2x Digital Outputs· RS485 I/O Expansion Port (RJ-45)· 9-24 VDC Power Input

DH2SR5000-DH2

· RS232 or RS485 Serial Interface (Modbus Master / Slave Function)

· 9-24 VDC Power Input

Wireless Digital I/O Module WM5000-004

· 6x ProgrammableDigital Channels

· 30 VDC (Max) Input for All Channels· 1 A Sink Current for Open-Drain Outputs· Configurable Debounce Filter· 9-30 VDC Power Input

Wireless AnalogInput ModuleWM5000-003

· 4x Analog Inputs 0-5 V, 0-10 V, or 4-20 mA

· Selectable Modes, 24-Bit ADC· 9-30 VDC Power Input

Analog Input ModuleWM3000-002

· 4x Analog Inputs 0-5 V, 0-10 V, or4-20 mA Selectable Modes, 24-Bit ADC

· 6-24 VDC Power Input

The patented Wireless System is comprised of Wireless

Transmitters, Wireless Gateways, I/O Expansion Modules, and

user-friendly BreeZ® Software. The Wireless System is a highly

reliable, scalable, �exible, and manageable solution that is ideal

for operation in remote and/or hazardous locations.

Wireless Transmitters: We o�er a comprehensive line of

transmitters for wirelessly monitoring various conditions

including liquid level, high level, pressure, �ow, temperature, and

triggering alarm. Our Wireless Transmitters are self-contained and

battery-powered, eliminating the need for external power.

Additionally, these devices are intrinsically safe for use in Class I,

Division 1 locations, while providing seamless integration with

third-party devices and sensors. The new WT series products

feature a local LCD display. This feature enables con�guring

device on-site without cables and allows instant readings without

connecting to a PC.

Wireless Gateways: We o�er two versions: Base Unit and

DH2. These Gateways collect data from end nodes in a

point-to-multipoint fashion. The collected data is exchanged with

backbone SCADA systems via Modbus (RS232/RS485 Serial Interface).

Additionally, multiple Gateways can be added to the same network

for peer-to-peer data sharing: mirror I/O, valve control, Emergency

Shut Down (ESD), and much more.

I/O Expansion Modules: These devices are o�ered in both

Wireless and Wired versions for expanding various I/O capabilities

to a network: both analog and discrete.

The Wireless devices are managed with the BreeZ® Software. It allows users to easily and quickly create a network, add devices

to a network, de�ne parameters and set transmission intervals for

each device using a PC.

OleumTech is a leading provider of wireless automation

solutions for industrial applications involving process monitoring

and control systems. Our products unite traditional control

infrastructures with cutting-edge wireless technology and

enables organizations to improve operational e�ciency and

productivity, reduce cost and meet regulatory compliance

requirements.

Since 2002, OleumTech has been committed to the needs of

mission-critical wireless automation applications in the Oil & Gas,

Re�ning, Petro-Chemical, Utilities, Water/Wastewater industries,

and many others.

INDUSTRIAL WIRELESS AUTOMATION

COMPANY PROFILE

Help Meet RegulatoryCompliance

Gain CompetitiveAdvantage

Improve OperatorSafety

Reduce OperatingCost

Rapid Implementation

WIRELESS GATEWAYS

ISO9001

OleumTech

REGISTERED COMPANY

ISO9001

Man

ufac

tu

ring

Support Engineering

Sales & Marketing Application

R&D

and

Continuous Customer

Techni

cal

Improvem

ent Service

Suppor

t

Base Unit Connected to I/O Expansion Modules via RS-485

· Set-Point Level Detection· Includes Level Switch Shown· Mounts on Side of Tank

High Level Switch Transmitter - SideWT-0900-HL2

· Set-Point Level Detection· 1 or 2 Actuation Points for High & High-High Level· Switch Length Up to 6 ft. (Custom Lengths Also Available)· Mounts on Top of Tank

High Level SwitchTransmitter - Top WT-0900-HL1

WIRELESS TRANSMITTERS 900 MHz or 2.4 GHz, Battery-Powered, Point-to-Point, Up to 7500 ft. Range (900 MHz)

LCD WIRELESS TRANSMITTERS900 MHz or 2.4 GHz, Battery-Powered, Point-to-Point, Up to 7500 ft. Range (900 MHz)

High Level SwitchTransmitter - Top

· Set-Point Level Detection· 1 or 2 Actuation Points for High & High-High Level· Switch Length Up to 6 ft. (Custom Lengths Also Available)· Mounts on Top of Tank

· Monitors Flare, Kilns, Gas Turbine, etc.· Supports Thermocouple Sensor Type K· Compatible with Third-Party Sensors· Units in US or Metric· Provides Wiring Board

ThermocoupleTransmitter SM5000-TC1

· Monitors On/Off, Open/Closed Status, or Alarm Conditions· 2x Discrete Inputs· Open-Drain or Dry Contact (NPN)· DS1: Flying Leads / No Junction Box· DJ1: Includes Junction Box

DiscreteTransmitter SM5000-DS1SM5000-DJ1

H-SERIES HARDWIRED SENSOR

· High Resolution Magnetostrictive· Product, Interface & Temperature Levels· Rigid / Flex / Ultra-Flex Sensor· Single or Dual Float· Standard or Large Float Size

Liquid Level SensorHW5000-LS1 (Modbus)HW5000-LS2 (LevelMaster ASCII)

Shown with Rigid Sensor - 316 SS

Hydrostatic LevelTransmitter LM5000-HP1

· Low-Cost Liquid Level Solution· For Vented Tanks and Wells· Custom Lengths Available up to 70 ft.

AnalogTransmitter SM5100-P01SM5100-P02SM5100-P04

· 1, 2, or 4x Analog Input Option· 0-5 V, 24-bit ADC· Flying Leads· Junction Box Optional

· Product, Interface & Temperature Levels· High Resolution Magnetostrictive· Rigid / Flex / Ultra-Flex Sensor· Single or Dual-Float· Standard or Large Float Size

Digital Level Transmitter LM5000-WDG

RTD TemperatureTransmitter SM5000-RTDSM5000-RTM

· Monitors Air, Gas, Water, or Liquid Temperatures· Supports All Platinum 100 Ohm Sensors· RTD (Direct Mount): Includes Sensor· RTM (Multi-Vendor): Includes Junction Box

Shown with Rigid Sensor withLarge Floats & High Level Switch

Liquid Level TransmitterMagnetostrictiveWT-0900-LL2

· Product, Interface & Temperature Levels· Rigid / Flex / Ultra-Flex Sensor· Single or Dual Float· Standard or Large Float Size· Includes Junction Box for Wiring· 2x Discrete Inputs

· 1x Analog Input (0-5 V, 24-Bit ADC) · LL4 (Direct-Mount): Includes Sensor & 1.5” NPT Male Adjustable Compression Fitting· LL5 (Multi-Vendor Version): Includes Junction Box & Strain Relief Solution

Liquid Level TransmitterHydrostaticWT-0900-LL4WT-0900-LL5

SM5000-HLT

· Same Features as WDG, but with Quick Connect Adapter· No Wiring Involved

Digital LevelTransmitterQuick Connect LM5000-WDG-QC

· 3x Analog Inputs (0-5 V, 24-Bit ADC)· 1x Discrete Input (For Dry-Contact or Open-Drain Output Device)· Allows Zero and Max Callibration· Includes 1/2” Reducing Bushing· Provides Terminal Block for Easy Wiring

Analog/PressureTransmitter WT-0900-AD1

· Non-Contact Level Monitoring Solution· 1 ft to 12 ft Level Reading Range· Includes Sensor· Includes 1.5” NPT Male Adjustable Compression Fitting

Liquid Level TransmitterUltrasonicWT-0900-LL6

· 2x Discrete Inputs On/Off, Open/Closed, or Alarm· Normally Open or Closed Input Function· On-Delay Exception Reporting· Direct or Pipe-Mount Version· Provides Terminal Block for Easy Wiring

DiscreteTransmitter WT-0900-DS1

· Monitors Flare, Kilns, Gas Turbine, etc.· Supports Thermocouple Sensor Type K· Compatible with Third-Party Sensors· Provides Wiring Board· Units in US or Metric

Transmitter WT-0900-TC1

Thermocouple

· Monitors Air, Gas, Water, or Liquid Temperatures· Supports 2, 3, or 4-Wire Sensor· Direct Mount (Includes Sensor) or Multi-Vendor

RTD TemperatureTransmitter WT-0900-RT1 (Direct Mount)WT-0900-RT2 (Multi-Vendor)

· High-Speed Pulse Counter (1 Hz-10 kHz)· Compatible with Third-Party Turbine Meters· Captures Today’s, Yesterday’s, and Raw Totals· Calculates Instantaneous Rate

Flow TotalizerTransmitter WT-0900-FT1

Quick Connect Eliminates Wiring and Junction Box

Shown withUltra-Flex Sensor

PressureTransmitter SM5000-JP1SM5000-JP2SM5000-JP4

· 1, 2, or 4x Pressure Input Option· Compatible with Third-Party Pressure Transducers· 0-5 V, 24-bit ADC· Flying Leads / Includes Junction Box

Cathodic ProtectionTransmitter

· Monitors Cathodic Protection Integrity· Current Range: 0-20, 0-40, or 0-80 A· 0-50 V DC Input for Monitoring Cathodic Rectifier DC Voltage Output· Provides Terminal Block for Easy Wiring· Includes DC Current Sensor

SM5000-CP1

High Level SwitchTransmitter - Side

· Set-Point Level Detection· Includes Level Switch Shown· Mounts on Side of Tank

SM5000-HLS

Liquid Level TransmitterMagnetostrictiveQuick ConnectWT-0900-LL1

· Product, Interface & Temperature Levels· Rigid / Flex / Ultra-Flex Sensor· Single or Dual-Float· Standard or Large Float Size· Quick Connect· No Wiring Involved

LL4 Shown

Shown withUltra-Flex Sensor