1
Part No. ZVW24298 Page 1 of 1 Iss 1 July 2010 THANK YOU FOR CHOOSING A ZUNSPORT PRODUCT. VW Golf R32 Mk IV Sports Grille Kit Kit Contents: - 1 off Centre Grille 1 off LH Side Grille 1 off RH Side Grille 2 off Screws No 6 x ¾¨ Tools required:- Philips screwdriver Masking tape Pointed nosed pliers Centre Mesh Grille Fitting Instructions 1. It is recommended that masking is used to protect any contacting painted surfaces during fitting. 2. Position the grille over the centre aperture, allowing sufficient space to slide the one end 2 retaining brackets behind the existing plastic vanes, Fig 1. 3. Whilst holding the grille in its one end retained position flex the centre of the grille and press the other end until the other 2 brackets engage and the grille slides into position, Fig 2. 4. Remove the masking tape and fitting of the centre grille is complete. Side Mesh Grille Fitting Instructions 1. It is recommended that masking tape is used to protect any contacting painted surfaces during fitting. 2. Position the grille in the bumper aperture and secure the wire bracket behind the bumper, Fig 3. 3. Make sure that the grille is central to the aperture and secure in position with the screw provided, Fig 4. 4. Repeat for the other side grille. 5. Remove the masking tape and fitting is complete. Fig 1 Fig 2 Fig 3 Fig 4

Part No. ZVW24298 VW Golf R32 Mk IV Sports Grille Kit

  • Upload
    others

  • View
    6

  • Download
    0

Embed Size (px)

Citation preview

Page 1: Part No. ZVW24298 VW Golf R32 Mk IV Sports Grille Kit

Part No. ZVW24298 Page 1 of 1 Iss 1 July 2010

THANK YOU FOR CHOOSING A ZUNSPORT PRODUCT.

VW Golf R32 Mk IV Sports Grille Kit

Kit Contents: -

1 off Centre Grille 1 off LH Side Grille 1 off RH Side Grille 2 off Screws No 6 x ¾¨

Tools required:- Philips screwdriver Masking tape

Pointed nosed pliers

Centre Mesh Grille Fitting Instructions

1. It is recommended that masking is used to protect any contacting painted surfaces during fitting.

2. Position the grille over the centre aperture, allowing sufficient space to slide the one end 2 retaining brackets behind the existing plastic vanes, Fig 1.

3. Whilst holding the grille in its one end retained position flex the centre of the grille and press the other end until the other 2 brackets engage and the grille slides into position, Fig 2.

4. Remove the masking tape and fitting of the centre grille is complete.

Side Mesh Grille Fitting Instructions

1. It is recommended that masking tape is used to protect any contacting painted surfaces during fitting.

2. Position the grille in the bumper aperture and secure the wire bracket behind the bumper, Fig 3. 3. Make sure that the grille is central to the aperture and secure in position with the screw provided, Fig 4. 4. Repeat for the other side grille. 5. Remove the masking tape and fitting is complete.

Fig 1

Fig 2

Fig 3

Fig 4