Upload
hamizan-mustaffa
View
114
Download
3
Embed Size (px)
Citation preview
Hamizan Mustaffa, Ahmad Tamimi, Dzulfarith Dzulkifli, Nur Fitrina, Amir Aziz, Rizalman Mamat
BackgroundBackground
Parachute Design for Recovery System of RocketParachute Design for Recovery System of Rocket
The aim of this research is to design and fabricate the parachute for rocket recovery system. It is very important since it can save the cost of rocket fabricating and will also help the researcher to study the characteristics of flight analysis that have been brought back in the rocket by recovery system. There are six main testing were conducted which is Cruciform, Hemispherical, Semi-ellipsoidal, Octagonal, Round and Square shape. Deployment test was conducted to identify the real performance of parachute when subjected to load upon air velocity respectively.
• The objective of the project is to design, fabricate and testing for rocket recovery system.
• Identify the real performance of parachute with the presence of payload and air.
Research team members from Faculty of Mechanical Engineering, Universiti Malaysia
Pahang (UMP)
Figure 1: Semi-ellipsoidal parachute inflated in air
Figure 2 : Hemispherical parachute inflated in air
Figure 3: Octagon parachute inflated in air
Figure 4: Cruciform inflated parachute in air
Table 1: Graph of time taken for parachutes landed by different weights.
ObjectiveObjective
ResultsResults
Parachute TestingParachute Testing
Team MembersTeam Members
Table 2: Speed calculation for parachutes
Nur FitrinaMat Nawi
Hamizan A.Tamimi Dzulfarith Amir Mustaffa A.Termizi Dzulkifli Aziz