Upload
roji-philip-n
View
214
Download
1
Embed Size (px)
DESCRIPTION
simplex power up
Citation preview
PANEL POWER UP GUIDELINES
• Check the incoming voltage – 240V/110V
• Connect the AC wires to the appropriate terminals
• Connect the Ground Wire to the Body of the Panel
• It is recommended that the power cable entry taken from bottom right side
of the panel
• Avoid any cable entry from beneath the panel box as this space is dedicated
to battery
• Building DB shall have a dedicated breaker with ‘Fire Alarm’ marking on it.
• It is recommended to install a Fused Spur Switch next to the panel or inside
the panel to isolate the power in case of requirement
• The AC wire plug from the SPS should be connected in the right direction-
Force entry of the plug will damage or blow up the fuse.
• it is recommended to have a junction box for the cables and conduits
before entering into the panel
• Once the system is stable connect the Battery leads
• Do not connect the batteries first
• To power down the panel the batteries shall be disconnected first and then
the AC power shall be switched OFF