Embed Size (px)
Citation preview
Circle 035 on reader information card
Carbon Adsorption Systems Baron-Blakeslee Inc. Long Beach, Calif.
Baron-Blakeslee’s carbon adsorp- tion systems reduce solvent vapor emissions while increasing solvent re- cycling efficiency. Up to 97% of cap- tured solvent vapors can be returned for reuse to the cleaning cycle. The operation of the carbon adsorbers con- sists of adsorption, desorption, air purge, and cool down. Features include programmable cycling, state-of-the-art controls, built-in safety control, auto-
matic cool-down cycle, automatic air- purge cycle, and a unique tank design.
Circle 406 on the reader service card
Centrifuge Barrett Cenfrifugals Inc. Worcester, Mass.
The Clarifuge uses up to 2,100 Gs of centrifugal force to rapidly separate suspended solids, including metal, abrasive stone, and dirt, from a wide variety of liquids without the need for cartridges, cloth, or paper filters. Sep- arated solids accumulate in the unit’s
rotating bowl while the clear liquid flows through an outlet hose so that it can be reused. Because most fluids can be cleaned and reused with virtually no deterioration in performance, new fluid expenses can be dramatically re- duced. The Clarifuge is available in a stationary or portable, cart-mounted configuration.
Circle 407 on the reader service card
Overspray Collector Chemco Mfg. Co. Inc. Northbrook, 111.
The Maxima paint overspray collec- tor was developed for high-solids baked enamels. The Maxima has a unique 2-in. thick dense microfilament weave. It has high paint holding capac- ity and a specially formulated backing for maximum efficiency with minimal pass-through. Available in pad, blan- ket, or roll form, the Maxima is also highly effective with water-based coat- ings, lacquers, stains, and sealers.
Circle 406 on the reader service card
Oil/Water Separator Colloid Environpental Technologies Co. Arlington Heights, I//.
Colloid Environmental Technolo- gies has introduced the OWS-Series oil/water separators. The OWS-Series products have a removal efficiency rate higher than 95%. Four standard models are capable of handling flow
66 METAL FINISHING . AUGUST 1997
