Oven Calibration Ring Procedure

1. Set the oven up as normal.2. Place the calibration ring in the oven as you would nor-

mally place products. This includes putting the base and beads in the main tray and then setting the cover on top.

3. Start a cycle you want to test (We suggest running a full contour cycle as that is the most used). You can run the ring with your production units if you desire.

4. Once the cycle is complete take the ring out and measure the outer diameter of the ring. Take a few measurements and take the average if different.

800.255.2839bnddental.comsales@bnddental.com