Embed Size (px)
Citation preview
Orion Telecom Networks Inc. - 2010 Slide 1
Ethernet over E1(FE1)
Updated: April 2010Orion Telecom Networks Inc. - 2010
Ethernet over E1 (FE1)Ethernet over E1 (FE1)
Product PresentationProduct Presentation
Orion Telecom Networks Inc. - 2010 Slide 2
Ethernet over E1(FE1)
Product Overview Ethernet over E1 Converter provides the user a facility to transport Ethernet
(multiple LANs) over an E1 link.
Very Compact and Low cost.
Converts and transports Ethernet sites over an E1 link
The device can effectively utilize the redundant bandwidth of telecom
operators' existing TDM network to transport Ethernet data with low
investment
Optional powers 220V AC and -48V DC
Provides 120 Ohms – RJ45 and 75 Ohms - BNC E1 interface in the same
box (user selectable)
Plug and Play
Orion Telecom Networks Inc. - 2010 Slide 3
Ethernet over E1(FE1)
The maximum transmission rate of Ethernet data over E1 links is 2.048 Mbit/s
Supporting 1600 frames, accordance with Interior Switching Link (ISL) Protocol
Supports unframed, framed and multi framed E1 transmission mode
Supporting local E1 port loop-back
The Ethernet Port is self-adaptive to crossover or shoot-through (Straight /
Parallel) cable to avoid the trouble of re-wiring
Ethernet negotiation function. Supports 10M/100M and working modes of both
full-duplex and semi-duplex
Transparently transmits ultra-long frames stipulated in IEEE 802.1Q, and
supports Ethernet switches with VLAN function.
Transport the DATA transparently (No configuration required)
Visual alarms (LEDs) on front panel
Features and Highlights
Orion Telecom Networks Inc. - 2010 Slide 4
Ethernet over E1(FE1)
Features and Highlights Imbedded, dynamic Ethernet MAC address list (1024 addresses), and filter
function for local data frames Can support multiple LANs of different network
addresses
Optional powers 220V AC and -48V DC
Supported fractional E1. E1 Bandwidth can be adjusted from 64 Kbps to 2048
Kbps and selected in N*64Kbps format
Provides 120 Ohms – RJ45 and 75 Ohms - BNC E1 interface in the same box
(user selectable)
Configurable Ethernet port speed (10 /100) and mode (Half / Full Duplex)
Ethernet port mode status (LEDs)
Plug and Play
Very compact and low power consumption.
Orion Telecom Networks Inc. - 2010 Slide 5
Ethernet over E1(FE1)
Applications This equipment may be used for the following purposes:
Bridging Ethernet LANs over existing TDM (E1) telecom network
Extending Ethernet Networks utilizing TDM (E1) landline based telecom
infrastructure
Using telecom network of E1s / PDH / SDH Microwave etc.
Carrying E1s to transport Ethernet data
In all these cases the equipment be always installed and used in pairs, with
one terminal being installed at either end (each side) of the network.
Orion Telecom Networks Inc. - 2010 Slide 6
Ethernet over E1(FE1)
Application Diagram
E1 Link
LAN
LAN
ROUTER
ROUTER
TDM
Network
E1 Link
Ethernet over E1
(FE1)
LAN
LAN
ROUTER
ROUTER
Ethernet over E1
(FE1)
Orion Telecom Networks Inc. - 2010 Slide 7
Ethernet over E1(FE1)
Front Panel Description
Orion Telecom Networks Inc. - 2010 Slide 8
Ethernet over E1(FE1)
Back Panel Description
Ethernet over E1 (220V AC Mains input)
Ethernet over E1 (-48V DC Mains input)
Orion Telecom Networks Inc. - 2010 Slide 9
Ethernet over E1(FE1)
Bottom Panel Description
Timeslot selection for the fraction E1 is given in the bottom of the equipment
Orion Telecom Networks Inc. - 2010 Slide 10
Ethernet over E1(FE1)
For more details visit us at our Website athttp://www.oriontelecom.com
Thank you for your attentionThank you for your attention
Regional Office: Miami, Florida
Orion Telecom Networks Inc.4000 Ponce de Leon Blvd. Suite 470,Coral Gables, FL 33146, U.S.A.Phone: 1-305-777-0419, Fax: 1-305-777-0201E-mail: [email protected]: http://www.oriontelecom.com
Headquarters: Phoenix, Arizona
Orion Telecom Networks Inc.16810, Avenue of the Fountains, Suite # 108, Fountain Hills, AZ 85268 U.S.A.Phone: +1 480-816-8672, Fax: +1 480-816-0115E-mail: [email protected]: http://www.oriontelecom.com
