Operate SINCGARS Single-Channel (SC)TASK: 113-587-2070

RULES1. IF YOU FEEL TIRED, STAND UP

2. PARTICIPATION IS A MUST

3. GIVE PROPER COURTESIES TO OTHERS

4. CELL PHONES SWITCHED TO VIBRATE OR OFF

5. PAY ATTENTION!

6. TAKE YOUR TRASH WITH YOU

Risks assessment: lowIn case of fire: exit the building immediately. in an orderly fashion walk not run to the nearest exit. We will form up in the front of the Building in the parking lot according to company and sections for 100% accountability.

Operate SINCGARS Single-Channel (SC)TASK: 113-587-2070

Instructors:

Conditions:

Given an operational SINCGARS, distant station, TM 11-5820-890-10-8, TM 11-5820-890-10-3, TM 5820-890-10-2, DA Pam 738-750 and simple key loader.

Standards:

The standards are met when a secure communications check is conducted in SC mode with a distant station.

**Reduced size and weight. Internal battery. Increased battery life. Enhanced display (Backlight level selectable). Only one front panel switch. Spare slots for future enhancements. Enhanced self -test (BIT) RT Mode may remain in FH to change net ID. Enhanced Operating Mode (EOM) All three digits of net ID may be changed by operator. Sync time may be loaded electronically from an Automated Net Control Device (ANCD), a Simple Key Loader (SKL), Precision Lightweight GPS Receiver (PLGR), Embedded GPS Receiver (EGR), manually via the keypad, or by ERF. RT will accept ERF if sync time is less than 100 days different from net sync time. New keypad with SIP features. GPS connector. AUX connector for HRCRD, 2-wire adapter, or CDU

Why do we use the RT-1523E:

The reliability of radio communications depends largely on the selection of a good radio site.

Since it is very difficult to select a site for a radio that satisfies all the technical, tactical, and security requirements, we compromise and select a primary site and an alternate site.

If, for some reason, radio communications cannot be established and maintained at the primary location, the radio equipment can be moved a short distance to the alternate site.

RELIABILITY

Capabilities and Limitations

The capabilities of the single-channel radio make it flexible, securable, mobile, and reliable.

Radio communications facilities usually can be installed more quickly than wire communications.

Thus, radio can be used as a primary means of communications during the initial stages of combat operations.

Once installed in a vehicle, aircraft, or ship, the equipment is ready for use and does not require reinstallation.

Wire communications require reinstallation with each move.Radio equipment is designed to meet mobility requirements and is used by airmobile, amphibious, mechanized, and dismounted units.

The limitations of single-channel radio must also be considered.Radio is the most detectable means of electronic communications and is subject to intentional and unintentional electronic interference.

Current Threat conditions require good electronic counter countermeasures (ECCM) to include remoting techniques.

To be capable of operating together, radios must have common or at least some overlapping frequencies.

They must transmit and receive the same type signal and must be located within operating range of each other with a clear transmission path.

Radio is the least secure means of communications, and it must be assumed that interception occurs every time a transmitter is placed in operation.

limitations of single-channel radio

PERFORMANCE STEPS

• PERFORM STARTING PROCEDURES• LOAD THE SIMPLE KEY LOADER• ENTER THE NET

a) Use correct procedures b) Conduct a secure communication check

• PREPAIR THE CONTROL MONITOR FOR OPERATIONS

• CHANGE THE RADIO FUNCTIONS USING CONTROL MONITOR

• PERFORM STOPPING PROCEDURES

STEPS

1. LOAD BATTERY2. SET OPERATOR’S SWITCHES AND CONTROLS

a. COMSEC SWITCH IN PTb. FUNCTION SWITCH IN LD

3. SET BATTERY LIFE CONDITION4. INSTALL ANTENNA & HANSET ON PROPER CONNECTORS

Steps Continued

5. Preset channel frequency(ies) 6. Perform shutdown procedures

a. set comsec switch to zb. turn function knob to z-fh, then offc. turn radio offd. remove battery

** must be completed within 3 minutes.**

QUESTIONS?

Check on learning

QUESTION 1

WHAT IS THE 2ND STEP TO OPERATING A SINCGARS RT 1523E radio?

SET OPERATOR’S SWITCHES AND CONTROLS

a. COMSEC SWITCH IN PTb. FUNCTION SWITCH IN LD

QUESTION 2

What does step 4 consist of?

INSTALL ANTENNA & HANSET ON PROPER CONNECTORS

True or False

You set comsec switch to z-fh then to off?

FALSEset comsec switch to zturn function knob to z-fh, then off

True or false

It is fairly easy to select an ideal site for a radio that satisfies all the technical, tactical, and security requirements?

FalseSince it is very difficult to select a site for a radio that satisfies all the technical, tactical, and security requirements, we compromise and select a primary site and an alternate site.

END OF 1st CLASS

Operate secure sincgars

INSTRUCTORS

Condition

Given an operational sincgars, transfer fill device with cable, distant end station, tm 11-5820-890-10-8, da pam 750-8, da form 2404, and unit soi

Standard:

STANDARD IS MET WHEN COMMUNICATIONS IS CONTINUED IN A SINGLE CHANNEL OR FREQUENCY HOPPING MODE OF OPERATION WITH A DISTANT END STATION, USING THE lcD DISPLAY AND THE “DURING” OPERATION CHECK RESULTS ARE RECORDED ON DA FORM 2404

Single-channel radio characteristics & capabilities

The Sincgars family is designed on a modular basis to achieve maximum commonality among various ground and airborne configurations.

A common RT is used in the manpack and all vehicle configurations. These individual components are totally interchangeable from one configuration to the next.

Single-channel radio characteristics & capabilities

Sincgars operates on any 2,320 channels between 30-88 MHz, with a channel separation of 25 kilohertz (KHz).

It is designed to operate in nuclear or hostile environments.

Sincgars accepts either digital or analog input and imposes the signal onto a Secured channel(SC) or Frequency hop (FH) output signal.

Single-channel radio characteristics & capabilities

In fh, the input changes frequencies about 100 times per second over portions of the tactical VHF range.

This hinders threat intercept and jamming units from locating or disrupting friendly communications.

Single-channel radio characteristics & capabilities

The Sincgars radio is compatible with current generations of single channel FM Radios in use of our NATO allies in single channel mode.

Since our nato allies have not yet fielded frequency hopping radios, they can only communicate on discrete frequencies.

STEPS

1) PERFORM START-UP PROCEDURES (SET RADIO TO GPS TIME)2) LOAD THE TRAFFIC ENCRIPTION KEY3) ENTER THE NET:

A) USE THE CORRECT PROCEDURES

B) CONDUCT A SECURE COMMUNICATION CHECK.

4) PREPAIR CONTROL MONITOR FOR OPERATIONS.

STEPS CONT.

5) PERFORM NET MEMBER CUE LATE ENTRY:

A) USE CORRECT PROCEDURESB) CONDUCT A SECURE

COMMUNICATION CHECK.6) CHANGE THE RADIO FUNCTIONS USING THE CONTROL MONITOR.7) EXIT THE NET8) PERFORM STOPPING PROCEDURES

QUESTIONS?

CHECK ON LEARNING

SINCGARS OPERATES ON HOW MANY CHANNELS?

a)2,450b)2,320c)2,420d)2,340e) None of the above

Answer:

b)2,320

Sincgars operates on any 2,320 channels

Your Sincgars radio was left in a vehicle and exposed to

an EMP due to a nuclear blast. Will your radio still

work?

possibleThe Sincgars radio is nuclear survivable in that it is hardened against the effects of emp. Although it is not as vulnerable to emp as other solid state electronic devices, do not think that it is invulnerable to emp. The Sincgars radio is designed to operate in nuclear or hostile environments.

True or false

Sincgars operates on any 2,320 channels between 30-88 KHz, with a channel separation of 25 kilohertz (KHz).

falseSincgars operates on any 2,320 channels between 30-88 MHz, with a channel separation of 25 kilohertz (KHz).

True or false We can communicate with the British royal army with the use

of our Sincgars radio?

TRUEBecause England is one of our nato allies we can communicate in single channel mode.

End of class