Just KissesDesigned by Wishwell for RKwww.robertkaufman.com

Featuring

ON THE FENCE

For questions about this pattern, please email Patterns@RobertKaufman.com.

Finished quilt measures: 67” x 70”Quilt shown in “MOSS” colorstory.

For alternate “SIENNA” colorstory see pages 11-12.

page 2

Fabric and Supplies Needed

ANJ-19796-155 STONE

ANJ-19790-70 AQUA

ANJ-19791-265 PARCHMENT

ANJ-19793-59 OCEAN

ANJ-19796-106 BLOSSOM

ANJ-19797-125 SUNFLOWER

ANJ-19795-45 MOSS

ANJ-19791-425 AQUAMARINE

ANJ-19797-405 WATERFALL

Fabric amounts based on yardage that is 42” wide.

A F

B G

H

I

C

D

E

1-1/3 yard 1-1/3 yard

3/4 yard 1-1/8 yard

2/3 yard

1/4 yard

1-1/8 yard

1-1/8 yard

1/4 yard

1/4 yard

Copyright 2020, Robert KaufmanFor individual use only - Not for resale

You will also need:4-1/4 yard for backing

fabric marking pen

ANJXD-19798-48 JUNGLE

Binding*

Color ColorFabric FabricName/SKU Name/SKUYardage Yardage

- Read through all of the instructions before beginning.- All of the seam allowances are 1/4” unless otherwise noted.- Press seam allowances open unless otherwise noted. - Width of fabric (WOF) is equal to at least 42” wide.- Right sides together has been abbreviated to RST.- Remember to measure twice and cut once!

Notes Before You Begin

page 3

From Fabric A, cut:one 3” x WOF strip. Subcut: nine 3” squares for the HSTsseventeen 2-1/2” x WOF strips. Subcut: seventeen 2-1/2” x 12-1/2” rectangles two 2-1/2” x 8-1/2” rectangles thirty-four 2-1/2” x 4-1/2” rectangles three 2-1/2” squares

From Fabric B, cut:one 3” x WOF strip. Subcut: nine 3” squares for the HSTsnine 2-1/2” x WOF strips. Subcut: eighteen 2-1/2” x 12-1/2” rectangles two 2-1/2” x 8-1/2” rectangles thirty-seven 2-1/2” squares

From Fabric C, cut:one 3” x WOF strip. Subcut: two 3” squares for the HSTsseven 2-1/2” x WOF strips. Subcut: eight 2-1/2” x 12-1/2” rectangles eight 2-1/2” x 16-1/2” rectangles one 2-1/2” x 6-1/2” rectangle two 2-1/2” squares

From Fabric D, cut:one 3” x WOF strip. Subcut: one 3” squares for the HSTs Trim the remainder of the strip to 2-1/2” wide, then subcut: one 2-1/2” x 12-1/2” rectangles one 2-1/2” x 6-1/2” rectangleone 2-1/2” x WOF strip. Subcut: two 2-1/2” x 16-1/2” rectangles

From Fabric E, cut:one 3” x WOF strip. Subcut: one 3” square for the HSTsfourteen 2-1/2” x WOF strips. Subcut: sixteen 2-1/2” x 12-1/2” rectangles sixteen 2-1/2” x 16-1/2” rectangles one 2-1/2” x 6-1/2” rectangle one 2-1/2” x 4-1/2” rectangle four 2-1/2” squares

Cutting Instructions

page 4

From Fabric F, cut:one 3” x WOF strip. Subcut: two 3” squares for the HSTsseventeen 2-1/2” x WOF strips. Subcut: twenty 2-1/2” x 12-1/2” rectangles twenty 2-1/2” x 16-1/2” rectangles five2-1/2”squares

From Fabric G, cut:one 3” x WOF strip. Subcut: four 3” squares for the HSTsfourteen 2-1/2” x WOF strips. Subcut: sixteen 2-1/2” x 12-1/2” rectangles sixteen 2-1/2” x 16-1/2” rectangles two 2-1/2” x 6-1/2” rectangles four 2-1/2” squares

From Fabric H, cut:one 3” x WOF strip. Subcut: two 3” squares for the HSTsfourteen 2-1/2” x WOF strips. Subcut: eight 2-1/2” x 12-1/2” rectangles eight 2-1/2” x 16-1/2” rectangles four 2-1/2” x 6-1/2” rectangles two 2-1/2” squares

From Fabric I, cut:one 3” x WOF strip. Subcut: one 3” square for the HSTs Trim the remainder of the strip to 2-1/2” wide, then subcut: two 2-1/2” x 16-1/2” rectanglestwo 2-1/2” x WOF strips. Subcut: two 2-1/2” x 12-1/2” rectangles two 2-1/2” x 8-1/2” rectangles

From the Binding Fabric, cut:three 2-1/2” x WOF strips

page 5

Step 1: Pair a 3” Fabric A square with a 3” Fabric I square, RST. Mark a diagonal line on the wrong side of one square. Sew 1/4” away from both sides of the marked line. Cut on the marked line, creating two half-square triangles (HSTs). Press toward the darker fabric. Trim to 2-1/2” square. Repeat to make two A/I HSTs.

Step 3: Gather:one Fabric H squaretwo Fabric B squarestwo Fabric A 2-1/2” x 4-1/2” rectangles one A/I HSTone B/H HST

Assemble the Half-Square Triangles (HSTs)

Assemble the Block Corner Unit

Step 2: Repeat Step 1 to make:

two B/H HSTs

six A/G HSTs (fivewillbeused)

four B/C HSTs

four B/F HSTs

four A/F HSTs

two B/D HSTs

four A/H HSTs

sixB/EHSTs(fivewill be used)

two A/E HSTs

Arrange the units into three rows. Note the fabric placement and block orientation in the Block Assembly Diagram.

Step 4: Sew the units together to form the rows. Press the seams in opposite directions every other row.

Step 5: Sew the rows together, nesting the seams and pressing the seams to one side to form the corner block unit. The Block should measure 6-1/2” square.

Repeat to make a second block with a Fabric H center.

page 6

Step 6: Repeat Steps 3-5 to make:

four Blocks with Fabric G centers

four Blocks with Fabric E centers

fiveBlockswithFabric F centers

two Blocks with Fabric C centers

Step 7: Gather:two 12-1/2” Fabric H stripstwo 12-1/2” Fabric I stripstwo 16-1/2” Fabric H stripstwo 16-1/2” Fabric I stripsone 12-1/2” Fabric A stripone 12-1/2” Fabric B stripone Step 5 Block with a Fabric H center

Assemble the Full Blocks

Arrange the units as shown. Note the fabric placement and block orientation in the Block Assembly Diagram.

Step 8: Sew the units together to form the H/I Block. Press.

Step 9: Repeat Steps 7 and 8 to make:

three G/H Blocks

four E/F Blocks

fiveF/GBlocks

two C/E Blocks

page 7

Step 10: On the back of each Block, mark the points indicated here with a fabric marking pen. Be sure that each point is 1/4” in from each raw edge of each corner point. These marks are important because they will indicate where you will start and stop your stitching in the y-seams throughout the pattern, so take extra care to mark accurately.

Step 11: Assemble the following partial blocks:

Assemble the Partial Blocks

one E/F Block without the Corner Block unit

one C/D Block without the Corner Block unit, and without the A strip or bottom D strip

one C/E Block without the Corner Block unit

one H/I Block with the Corner Block unit sewn to 8-1/2” A, B, H and I strips

one G/H Block with the Corner Block unit sewn to 8-1/2” A, B, H and I strips

two 6-1/2” C/E strip pairs two 6-1/2” C/D strip pairs

page 8

Step 12: Repeating Step 10, mark the points indicated with a fabric marking pen.

Assemble the Quilt

Step 13: Arrange the blocks, placing the partial blocks and the Fabric A and Fabric B squares as shown. Note the fabric placement and block orientation in the Quilt Assembly Diagram.

page 9

Step 14: Sew the blocks together to form diagonal rows, starting and stopping at the points indicated. Note that you will NOT start sewing at the raw edge of any of the blocks.

page 10

Step 15: Sew the rows together to form the quilt, starting and stopping at the points indicated. There will be a lot of stopping and starting and pivoting at each of the marked points, so take your time. Press.

Step 16:Trimthequiltasindicatedtoformthefinalshape.

Your quilt top is complete! Baste, quilt, bind and enjoy!

page 11

ON THE FENCE - Sienna Colorstory

page 12

Fabric and Supplies Needed

ON THE FENCE - Sienna Colorstory

ANJ-19796-155 STONE

ANJ-19789-179 RUST

ANJ-19791-265 PARCHMENT

ANJ-19797-170 SIENNA

ANJ-19790-119 MAUVE

ANJ-19796-106 BLOSSOM

ANJ-19793-221 AUBERGINE

ANJ-19790-135 MUSTARD

ANJ-19791-141 SAFFRON

Fabric amounts based on yardage that is 42” wide.

A F

B G

H

I

C

D

E

1-1/3 yard 1-1/3 yard

3/4 yard 1-1/8 yard

2/3 yard

1/4 yard

1-1/8 yard

1-1/8 yard

1/4 yard

5/8 yard

Copyright 2020, Robert KaufmanFor individual use only - Not for resale

You will also need:4-1/4 yard for backing

fabric marking pen

ANJXD-19798-161 STRAW

Binding*

Color ColorFabric FabricName/SKU Name/SKUYardage Yardage

This pattern may be used for personal purposes only and may not be reproduced in any form without the express permission from Robert Kaufman Fabrics. This pattern is not for resale. All patterns, unless otherwise attributed, are © Robert Kaufman Co., Inc. 2005-2020. All rights reserved.