6
OmniScan SX \ MX2 Training Program Overview - Introduction Chris Magruder

OmniSX MX2 Training 1 Overview

Embed Size (px)

DESCRIPTION

Training Omniscan MX2

Citation preview

Page 1: OmniSX MX2 Training 1 Overview

OmniScan SX \ MX2 Training Program

Overview - IntroductionChris Magruder

Page 2: OmniSX MX2 Training 1 Overview

OmniScan SX \ MX2 \ OmniPC Training - Overview

� The objective of the OmniScan SX\MX2 training program is to enhance the users

ability to work at a high level through self-paced instruction.

� The participant completing the course prior to attending instructor based training or

application development will be able to maximize their learning curve.

� This is achieved by learning the various software features and procedures of the

SX\MX2 while demonstrating their use in applications and Olympus products such as

the Cobra, Hydroform, WeldRover, and catalog scanners and probes through the

training material.

Page 3: OmniSX MX2 Training 1 Overview

OmniScan SX \ MX2 \ OmniPC Training – V4.1 Update

� The OmniScan SX\MX2 instruments, and OmniPC will all benefit from the new

features and functionality of MXU 4.1 because it is the same software.

� The OmniScan SX is a smaller lower cost instrument that comes with all the tools

and versatility of the MX2 limited to single probe, single group inspections.

� Primary benefits of V4.1 are enhanced full screen functionality, new interactive

menus, wizard improvements, and elimination of touch screen modes that are

explained in detail in the presentations.

Page 4: OmniSX MX2 Training 1 Overview

OmniScan SX \ MX2 \ OmniPC Training – Overview - Content

� The training program consists of 600+ Power Point slides, movies, and step by step

procedures demonstrating the various functions of the OmniScan SX\MX2 software

with a focus on applications and real world usage.

� The OmniScan SX\MX2 training program assumes that the participant has been

trained in convention UT and has little or no background or training in phased array

inspection.

� The majority of concepts, examples, and procedures throughout the course content

can be completed with a single phased array probe and wedge, and any calibration

block with a notch or side drilled hole. An IIW block, NAVShips block, or similar is

sufficient to reproduce most examples.

Page 5: OmniSX MX2 Training 1 Overview

OmniScan SX \ MX2 \ OmniPC Training – Overview – Content cont.

� Supporting documentation for the training program comes primarily from the MX2

software manuals and the Olympus reference manuals below.

� Modern phased array systems like the OmniScan SX\MX2 do not require an

advanced knowledge of mathematics or acoustic theory and the training program

focuses on practical explanations and real world examples for the working inspector.

� Supporting theory, mathematical formulas, and more advanced PA concepts can be

found in the books below available from the Olympus web site.

Page 6: OmniSX MX2 Training 1 Overview

Free Download Manager.lnk

Questions or comments:

[email protected]