!

Oliter- Military grade 1000 Ah, 2-volt gel batteries. Includes a two-shelf powder coated steel stand and joining plates.

!

Oliter gel battery & system prices.

Gel Batteries: 24 x 1000-Ah, 2-volt gel batteries with high C10 rating $21,000 Inc GST. 1 x 200-Ah, 12-volt gel battery. $550 Inc GST.

Full off grid System: 24 x 1000-Ah, 2-volt gel batteries. CEC approved. 18 x Resun 265-watt solar panels. CEC approved. Midnite Classic-150 MPPT charge controller. CEC approved. Total cost of the above $26,700 inc GST. You will need to add a CEC approved inverter to the above system price to be eligible for a Government rebate of up to $4000. We do stock lower cost inverters; these are not on the CEC approval list. If using one of these, the Government rebate is not valid. Expect to pay close to $4000 for a CEC approved 5-kilowatt inverter to be eligible for a Government rebate.

Special: Only one system left at this price $22,680 Inc GST: 24 x 1000-Ah, 2-volt gel batteries, includes powder coated stand & joining plates. CEC approved. 18 x Resun 250-watt mono crystalline solar panels. Fire tested and CEC approved.

Solar Panel prices currently in stock. 150-watt mono for 12-volt system $200 each. 250-watt mono for 24-48 volt off grid systems $300 each. SPECIAL: 300-watt mono for 24-48 volt systems $350. only 3 left. New 265-watt mono panels due in December 2015.

Midnite Classic-150 MPPT charge controller. IEC62109-1 approved and listed as an approved product on the clean energy council website. Remote power systems are eligible for STC rebates when using all approved products. !

This high spec controller allows 18 of our Resun 265-watt mono crystalline solar panels to be connected when using a 48-volt battery bank. That is a solar array size of 4770-wats = 4.77 Kilowatts. This still keeps the array size under all maximum parameters on the Midnite classic-150 controller. The panels are connected in 6 strings of 3 panels in each string. Each string will only carry between 8-9 Amps between the solar panels and the controller eliminating large power losses. The MPPT technology then converts the power to the correct battery voltage and has a maximum output battery charging current of 96 Amps. !

Zylux Energy Pty. Ltd. (Trading as D.C. Solutions Australia Pty. Ltd.)166 Christm

as Street, Fair!eld, VIC, 3078, Australia.Tel: (03) 9482 2203 Fax: (03) 9486 2297

Website: www.zyluxenergy.com

.au Email: info@zylux.com

.au

12 Through 72 volts on Classic's. Lite requires PC or MNGP for advanced feature programming

Classic 150 = 96A on 12V, 94A on 24V and 86A on 48V battery

Classic150 = 150V + HyperVOC (battery voltage up to 48V) Example 150V + 48V = 198VOC(NOTE: See HyperVOC at bottom)

98% (Typical system)2.8W - 4WZero - Internal relay for reverse currentLow Battery voltage disconnect and re-connect of loads fully programmable with 2 Auxiliary outputs to control external load disconnect /re-connect switchesStandard all models - Extended VOC range for cold climatesNot available on this Classic 150 IEC 62109-1 approved modelStandard all models - resettable, no fuse to blowBulk, Absorb, Float as well as Equalization10-100VDCAdjustable Voltage and Duration, Manual or AutoProtected to Max VOC ( Classic MPPT Charger Controllers are fully protected from reverse current on both input and output)Fully protected ( Classic MPPT Charger Controllers are fully protected from reverse current on both input and output)Fully protected (Classic MPPT Charger Controllers are fully protected from over current on both input and output)Fully protectedAutomatic when BTS is installed, Adjustable mV per degree C per 2V cell2 Auxiliary outputs, Aux1 can be 12V out or dry contact, Aux2 is 12V out or Logic INGraphical display - MNGPStandard 4 conductor phone cable, no hub neededRS232, Ethernet and ModBus openly published protocolDisplay (MNGP) can be relocated and a second display can be addedLocal Application software included allows viewing and control from the network or over the Internet. MyMidNite.com - online status monitoring

75 CAll models380 days of daily history, 24 hours of data at 5 minute intervalsStandard on all models, requires a PC or MNGP on the LiteRequires 2 pole input and output breakersMinimum of -40C to 50C - Controller will auto derate as temperature rises above 25CIndoor type IP30 (The Classic is IP22 Rated to 60529 when used with Classic Drip Shield)Single 1" conduit (35.05mm) on left and right sides. Two 1" conduit (35.05mm) on bottom. Two 3/4" conduit (27.76mm) on back.5 Year standard12 Lbs. (5.45 kgs) - 14.9" x 6" x 4" (378mm x 152mm x 102mm)19" x 8.5" x 5.7" (482.6mm x 215.9mm x 144.78mm)

Nominal Battery Voltage

Maximum Output Current PV Open Circuit Voltage VOC(NOTE: See HyperVOC at bottom)

Maximum Stand-By Self-Consumption (12V)Reverse Current At NightLow Battery Voltage Hyper VOC (NOTE: See HyperVOC at bottom)Arc Fault ProtectionGround Fault ProtectionCharging RegulationBattery Voltage Regulation Set PointsEqualization ChargingPV Reverse PolarityBattery Reverse PolarityBattery Over VoltageBattery Short CircuitBattery Temp CompensationProgrammable Auxiliary Control OutputGraphic DisplayNetworking CablingCommunicationsRemote DisplayRemote Monitoring And Control

Terminal RatingInternet ReadyData LoggingWind And Hydro ApplicationsPositive Ground ApplicationsOperating TemperatureEnvironmental RatingConduit knock OutsWarrantyWeight & Dimensions Shipping Dimensions HxWxD

HyerVOC: A non-operative VOC safety zone over and above the maximum input voltage for cold climates. Speci!cations subject to change without notice.

Classic 150 MPPT Charge Controller Speci!cations

USB input Not available on this Classic 150 IEC 62109-1 approved model

$1200 inc GST as of 17-10-16

Value Regulators Prices reduced on the 17-10-16 10-Amp, PWM regulator for 12V or 24V batteries. $40

Input rated voltage: 12V or 24V auto work. Loading current Max: 10A/12V or 10A/24V. Full charge cut: 13.7V/12V or 27.4V/24V. Low voltage cut: 10.5V/12V or 21V/24V. Output voltage: 12.6V/12V or 25.2V/24V. No load loss: <20mA. Voltage drop: !150mv.

20-Amp, PWM regulator for 12V or 24V batteries. $60 Input rated voltage: 12V or 24V auto work.

Loading current Max: 20A/12V or 20A/24V. Full charge cut: 13.7V/12V or 27.4V/24V. Low voltage cut: 10.5V/12V or 21V/24V. Output voltage: 12.6V/12V or 25.2V/24V. No load loss: <20mA. Voltage drop: !150mv.!

50-Amp, PWM regulator for 12V or 24V batteries. $170 50A solar charge controller with LCD display. Input rated voltage: 12V or 24V auto work. Loading current Max: 50A. Full charge cut: 13.7V/12V or 27.4V/24V. Low voltage cut: 10.5V/12V or 21C/24V. Output voltage: 12.6V/12V or 25.2V/24V. No load loss: <30mA. Voltage drop: <200mV.

50-Amp, PWM regulator for 48V batteries. $220 50A solar charge controller with LCD display. Input rated voltage: 48V. Loading current Max: 50A. Full charge cut: 54.8V. Low voltage cut: 42V. Output voltage: 50.4V No load loss: <30mA. Voltage drop: !270mV.

!

!

!

Resun mono crystalline 60-cell solar modules . Distributed by Run On Sun Australia Pty Ltd. These are one of only a few solar modules in Australia that have CEC fire testing certification through to October 2020.

Pure sine wave low frequency inverter/chargers. These inverter /chargers are a lower cost model than the U.S.A. built range. “Run On Sun Australia” have had these low frequency inverter/chargers operating in the real world for over 3.5 years has of October 2016 and they have proven to be totally reliable. A low frequency inverter is built using heavy copper windings, which means they are not relying on complex circuitry to operate making them more robust and reliable than most high frequency inverters. Note: This product family is NOT approved to provide a grid tie connect function in Australia and must not be enabled.

!

!

!

!

!

!

!

!

!

!

!

! !

1. 12-Volt, 1-Kw with 2-Kw surge $650. 2. 12-Volt, 1.5-Kw with 3-Kw surge $850. 3. 24-Volt, 1.5Kw with 3-Kw surge $900 Automatic transfer switch. 10-ms transfer time. 1. Charge current: 35-A with 3-step battery charging. 2. Charge current: 45-A with 3-step battery charging. 3. Charge current: 25-A with 3-step battery charging. Output 240-Volts at 50-Hz. High overload ability, 200% surge for 5-minutes, 300% surge for 20-seconds. Efficiency > 86%. Product size 446*218*179mm.

4. 24-Volt, 3-Kw with 6-Kw surge $1190 5. 48-Volt, 3-Kw with 6-Kw surge $1290 Automatic transfer switch. 10-ms transfer time. 4. Charge current: 45-A with 3-step battery charging. 5. Charge current: 30-A with 3-step battery charging. Output 240-Volts at 50-Hz. High overload ability, 200% surge for 5-minutes, 300% surge for 20-seconds. Efficiency > 86%. Product size 442*218*179mm.

6. 24-Volt, 5-Kw with 10-Kw surge $1590 7. 48-Volt, 5-Kw with 10-Kw surge $1650 Automatic transfer switch. 10-ms transfer time. 6. Charge current: 70-A with 3-step battery charging. 7. Charge current: 40-A with 3-step battery charging. Output 240-Volts at 50-Hz. High overload ability, 200% surge for 5-minutes, 300% surge for 20-seconds. Efficiency > 86%. Product size 598*315*300mm.

!