Upload
venkata-rao
View
12
Download
6
Embed Size (px)
DESCRIPTION
Nitotile Grout
Citation preview
Nito
tile
Gro
ut
Nitotile Grout*
Cementitious grout for ceramic tiles
Uses
As a grout for dry tile joints in:
n Kitchens
n Bathrooms
n Shower stalls
n Swimming pools
Advantages
n Low cost service life - mould resistant, tropical grade suits
Middle East working conditions
n Easy to apply - just add water for a thixotropic, non-slump
grout
n Can be used in submerged conditions
n Available in a range of attractive colours
Description
Nitotile Grout is a blend of specially selected cements, fillersand synthetic organic polymers. When added to water it
readily blends to produce a smooth creamy paste which whenset is water and mould resistant. Nitotile Grout is used inconjunction with Nitotile* tile adhesives.
Properties
Typical Properties of mixed material.
Working time at 200C : 90 minutesWorking time at 350C : 30 minutesCompressive strength : 38 N/mm2 @ 28 days(ASTM C 109)Tensile strength : 3 N/mm @ 28 days(BS 6319: Pt 7)
Instructions for use
Preparation
All tiles must be securely fixed in place and thoroughly cleanedbefore Nitotile Grout is applied. The gap between tiles shouldnot exceed 4mm.
Mixing
3.3 litres of water are required for each 10 kg bag of Nitotile
Grout. A slow speed drill fitted with a suitable mixing paddleis recommended. Add powder to water and mix until a uniform,lump-free, thick creamy paste is produced, allow to stand for
ten minutes prior to use.
Application
Apply Nitotile Grout to the spaces between the tiles using asponge or a small piece of soft cloth. Work the mixture into
the joints and around the edges.
Remove surplus material from the face of the tiles with a drycloth and run the tip of a gloved finger or suitable rounded
tool along the grout to level it off and form a profile.
When the grout is dry, clean the tiles with a damp sponge to
remove any excess material. It is advisable to remove uncuredgrout from textured tiles prior to setting, failure to do so mayresult in difficulty in removal.
Cleaning
Nitotile Grout should be removed from tools, equipment and
mixers with clean water immediately after use. Cured materialcan only be removed mechanically.
Limitations
Nitotile Grout should not be used when the temperature is
below 50C and falling. The product should not be exposedto moving water during application. If any doubts ariseconcerning temperature or substrate conditions, consult your
local Fosroc office.
Estimating
SupplyNitotile Grout : 10 kg bags
CoverageNitotile Grout : 4.0 m2/kg
Note: The actual coverage rate is dependent upon the type,size and spacing of tiles.
Storage
Shelf life
Nitotile Grout has a shelf life of 12 months if kept in a dry store
in the original, unopened bags or packs.
Storage conditions
Store in dry conditions in the original, unopened bags or packs.If stored at high temperature and / or high humidity conditionsthe shelf life may be reduced to 4 to 6 months.
UAE/0226/01/Ewww.fosrocgulf.com
Al Gurg Fosroc LLC
P. O. Box 657DubaiUnited Arab Emirates
TEL : (04) 285 8606FAX : (04) 285 9649
REGIONAL SALES OFFICES IN :
Important note
Fosroc products are guaranteed against defective materials and manufacture and are sold subject to its standard terms and conditions of sale, copies of which
may be obtained on request. Whilst Fosroc endeavours to ensure that the technical information on this data sheet is correct at the time of printing, it is the
customers responsibility to satisfy himself, by checking with the company that this information is still current at the time of use, that the product is suitable for
the intended application, and that the actual conditions of use are in accordance with those recommended. Because Fosroc has no control over the conditions of
use of its products, all recommendations or suggestions regarding the use of these products are made without guarantee.
ABU DHABI
Al Gurg Fosroc
TEL : 673 1779
FAX : 673 1449
BAHRAIN
YBA Kanoo
TEL : 738200
FAX : 732828
KUWAIT
Boodai
TEL : 481 7618
FAX : 483 2124
OMAN
GETCO
TEL : 771 5080
FAX : 771 7554
QATAR
Tadmur
TEL : 441 3628
FAX : 444 0812
DUBAI
Al Gurg Fosroc
TEL : 285 8787
FAX : 285 2023
Technical support
Fosroc offers a comprehensive range of high performance,
high quality repair, maintenance and construction products.In addition, Fosroc offers a technical support package tospecifiers, end-users and contractors, as well as on-site
technical assistance in locations all over the world.
Precautions
Health and safety
Nitotile Grout is cement based. Care should be taken toavoid inhalation of dust and contact with eyes. All cementbased products, when mixed or damp release alkalis which
can be harmful to the skin.
* Denotes the trade mark of Fosroc International Limited.
Additional Information
Nitotile Grout is part of a range of Fosroc tile adhesives and
tile grouts.
Fosroc manufactures a wide range of complementaryproducts which include:
n Waterproofing membranes & waterstops
n Joint sealants & filler boards
n Cementitious & epoxy grouts
n Specialised flooring materials
Fosroc additionally offers a comprehensive package ofproducts specifically designed for the repair and
refurbishment of damaged concrete. Fosrocs SystematicApproach to concrete repair features the following:
n Hand-placed repair mortars
n Spray grade repair mortars
n Fluid micro-concretes
n Chemically resistant epoxy mortars
n Anti-carbonation/anti-chloride protective coatings
n Chemical and abrasion resistant coatings
For further information on any of the above, please consult
your local Fosroc office - as below.