Mplab Cardona

  • Published on
    18-Aug-2015

  • View
    218

  • Download
    5

Embed Size (px)

DESCRIPTION

mplab manual

Transcript

<p>MPLABXc8Getting StartedGuide 1CREATION OF A PROJECT IN MPLAB X IDE:This section describes how to create a project in MPLAB X ID using the MPLAB X!8 ! !o"pi#er$ The process is e%p#ained in the &amp;o##owing steps' Step 1 sets the project t(pe$ Step ) se#ects the target de*ice$ Step + se#ects the de*ice header$ Step , se#ects the too# to run the project code$ Step - is on#( app#icab#e to so"e debugger too# se#ections$ Step . se#ects the too# to co"pi#e the source code$ Step / speci0es the project na"e and path$ Step 8 co"p#etes creation o&amp; the project$Step 1 sets the project t(pe'1ro" MPLAB X ID2 choose 1i#e34ew Project$$$$ In the window that opens 5as shown in 1igure 16172 se#ect the 8Microchip "bedded9 categor(2 and a 8Standa#one Project9 &amp;ro" the Projects 0e#d$)Step 2 se#ects the target de*ice'This se#ection "ust e%act#( "atch the de*ice on (our hardware$ 5I&amp; (ou are using the si"u#ator without hardware2 (ou can choose an( de*ice$7 To "a:e se#ecting a de*ice si"p#er2 de*ices are organi;ed into &amp;a"i#ies$ MPLAB X!8 can co"pi#e &amp;or an( de*ice in the 86bit6"icrocontro##er &amp;a"i#ies$ In 1igure 16)2 a PI!1818/</p>