Upload
tabitha-harmon
View
214
Download
1
Embed Size (px)
Citation preview
Mixer Settings for SHS Band Room
Plug mics in Bal/UnbalStarting with mic 1
Plug RCA cables in Tape Output to connectTo Computer input
Connect powered speakersTo Main Out
Use these controls to adjust the Starting volume of each mic
Low cut buttonShould be UP
These controlsare not used
These controlsare used to controlFeedback if needed
PAN is used to controlif this mic is in left or right channel
SOLO PFL should be UP
The fader (slider) is used to control the volume ofthis mic
MUTE should be UP
1 - 2 should be DOWN
3 - 4 should be UP
Equalizer can changethe balance of the frequencies of the music
BREAK SWITCH should be UP
SUB 1 •Left should be DOWN•Right should be UP
SUB 2 •Left should be UP•Right should be DOWN
Sub 1 is used to control the volume of the leftchannel
Sub 2 is used to control the volume of the rightchannel
Sub 3 & 4 are not used
Main mix is used to control all the volume for powered speakers
Lights indicate how loud each channel is
Phantom Power should be DOWN
All other controls arenot used.
Out to the stereo
In from the mixer