LACEY-HARMER CO.......................................................................................................................METAL DETECTORS By:

FEATURESFail Safe Electronic Design

Funct ion Monitor System

Ten Sensi t iv i ty Sett ings

Two Sol id State Control Relays

Modular Construct ion(Plug- in electr ic modules)

Wide Temperature Operat ing Range(-15C to +55C Ambient air temp)

Large Meter Readout

Manual or Automat ic Reset Mode

Wide Select ion of Search Coi ls

Power Input Opt ion -120/240V(50-60Hz AC 1 phase)

Ferrous & Non-Ferrous Metal Detect ion

Three Year Warranty L240 CONTROL INSTRUMENT

SHIELD X A-10 SEARCH COIL

RENS Model L240 Control Instrument has proven itself in hundreds of installations in the United States, Canada, and in other countries.

In combination with a RENS Shielded Search Coil it is highly cost effective in almost all oper-ating environments.

Custom built fiberglass sections for the Search Coil installation area are also available.

L240 CONTROL INSTRUMENT

INSTRUMENT WITH SHIELD XSEARCH COIL

8717 132nd Street Surrey BC V3W 4P1Tel: 604.599.9598 Fax: 604.599.9509Toll Free: 1.888.298.9877

Install fiberglass or wood conveyor section and Search Coil at adequate distance from the equipment to be protected to allow for belt travel after Detector stops drive motor.

Secure Search Coil with lightly driven wood shims at the sides of the coil.

Special Requirements:Conveyor belt must be vulcanized. Metallic fasteners may not be used.

A 50' length of shielded cable is furnished to connect Search Coil to Control Instrument. Control Instrument must be at least three feet away from the Coil.

RENS under conveyor Search Coils are designed for use with belt, vibrating and other custom conveyor systems. The Shield X design allows coil operation in difficult environmental surroundings.

Rugged construction, interior shock proofing and an all weather terminal box combine for long trouble free service.

FIBERGLASS SECTION WITH

SEARCH COIL POCKET

MIN. LENGTH REQ.5’ FOR A10 COIL6’ FOR A20 COIL

Scanning A10 Detection A20 Detection Width Height Height

14” 9 1/2 ------20” 9” ------24” 8 1/2” 13”30” 8” 12 1/4”36” 7 1/2” 11 1/2”42” 7” 11”48” 6 1/2” 10 1/2”54” 5 1/2” 10”60” 5” 9”

Coil Length X = Scanning Width + 8"

X8"

24"

7" X

A20

A10

12.5"

LACEY-HARMER CO.......................................................................................................................METAL DETECTORS By:

I N S TA L L AT I O N

SENSITIVITY TABLE

S H I E L D X

Maximum detection height of 1" steel ball at high sensitivity setting and in the optimum belt speed range of 100-350 fpm.

Troughed BeltApplications

A10TA20T

#199 Rev 8/05