4
Bookmark this page Send to friend Print this page Normal Search | Advanced Search > [Physical Properties>Treatability (amenability to preservative treatment)>Difficult ] Light Red Meranti INTRODUCTION The Standard Malaysian Name for the pink-red and lightweight timber of the genus Shorea (Dipterocarpaceae). Vernacular names used include majau (Sabah), meranti (Peninsular Malaysia and Sarawak) with various epithets, seraya batu (Sabah) with various epithets, red seraya (Sabah) and various other local names too numerous to list here. Major species include S. acuminata (partly), S. dasyphylla, S. hemsleyana, S. johorensis, S. lepidota, S. leprosula, S. ovalis, S. palembanica, S. parvifolia, S. platycarpa (partly) and S. teysmanniana. The sapwood is lighter in colour, usually greyish and distinct from the heartwood, which is light pink to light red or light brown. Also known as Light Red Meranti (Brunei); Meranti merah, Meranti merah muda, Seraya merah, Tangile and Urung (Indonesia); Almon, Light red lauan, Light Red Philippine Mahogany and Mayapis (Philippines); and Saya and Saya-khao (Thailand). DENSITY This is a Light Hardwood with a density of 385-755 kg/m 3 air dry. NATURAL DURABILITY Light red meranti (LRM) is not durable when used in contact with the ground or in exposed conditions. The heartwood is resistant to fungal attacks but not resistant to termite attacks. However, the sapwood of the timber is liable to attack by drywood termites which may subsequently spread to the heartwood. Almost all the species of LRM are resistant to powder-post beetle attacks (Menon, 1957). The standard graveyard tests conducted at the Forest Research Institute Malaysia (FRIM) have indicated that the average service life of this timber is less than two years and is therefore classified as not durable (Jackson, 1965; Dahlan & Tam, in press). However, this classification applies to the less durable species like S. ovalis, S. leprosula and S. teysmanniana. For S. acuminata, S. parvifolia and S. hemsleyana, the average service life is more than two years and are classified as moderately durable. Similar tests done at Princess Risborough (U.K.) showed that it is moderately durable with a service life of 15-25 years when in contact with the ground (Anon., 1975). It was reported by Burgess (1966) that the timber is highly susceptible to attack by marine borers. PRESERVATIVE TREATMENT The LRM is generally resistant to preservative impregnation. TEXTURE Texture is coarse but even, with interlocked grain. STRENGTH PROPERTIES The timber falls into Strength Group C (Engku, 1988b) or SG 6 (MS 544:Part 2:2001). Strength Properties of LRM Species Test Condition Modulus of Elasticity (MPa) Modulus of Rupture (MPa) Compression parallel to grain (MPa) Compression perpendicular to grain (MPa) Shear strength (MPa) Page 1 of 4 MTC Wood Wizard 1/23/2013 http://woodwizard.mtc.com.my:8888/report.asp?AttrID=82&ItemID=76

meranti properties

Embed Size (px)

DESCRIPTION

meranti properties

Citation preview

Page 1: meranti properties

 

Bookmark this page Send to friend Print this page

     

Normal Search | Advanced Search > [Physical Properties>Treatability (amenability to preservative treatment)>Difficult ]

Light Red Meranti

INTRODUCTION

The Standard Malaysian Name for the pink-red and lightweight timber of the genus Shorea (Dipterocarpaceae). Vernacular names used include majau (Sabah), meranti (Peninsular Malaysia and Sarawak) with various epithets, seraya batu (Sabah) with various epithets, red seraya (Sabah) and various other local names too numerous to list here. Major species include S. acuminata (partly), S. dasyphylla, S. hemsleyana, S. johorensis, S. lepidota, S. leprosula, S. ovalis, S. palembanica, S. parvifolia, S. platycarpa (partly) and S. teysmanniana. The sapwood is lighter in colour, usually greyish and distinct from the heartwood, which is light pink to light red or light brown.

Also known as Light Red Meranti (Brunei); Meranti merah, Meranti merah muda, Seraya merah, Tangile and Urung (Indonesia); Almon, Light red lauan, Light Red Philippine Mahogany and Mayapis (Philippines); and Saya and Saya-khao (Thailand).

DENSITY

This is a Light Hardwood with a density of 385-755 kg/m3 air dry.

NATURAL DURABILITY

Light red meranti (LRM) is not durable when used in contact with the ground or in exposed conditions. The heartwood is resistant to fungal attacks but not resistant to termite attacks. However, the sapwood of the timber is liable to attack by drywood termites which may subsequently spread to the heartwood. Almost all the species of LRM are resistant to powder-post beetle attacks (Menon, 1957). The standard graveyard tests conducted at the Forest Research Institute Malaysia (FRIM) have indicated that the average service life of this timber is less than two years and is therefore classified as not durable (Jackson, 1965; Dahlan & Tam, in press). However, this classification applies to the less durable species like S. ovalis, S. leprosula and S. teysmanniana. For S. acuminata, S. parvifolia and S. hemsleyana, the average service life is more than two years and are classified as moderately durable. Similar tests done at Princess Risborough (U.K.) showed that it is moderately durable with a service life of 15-25 years when in contact with the ground (Anon., 1975). It was reported by Burgess (1966) that the timber is highly susceptible to attack by marine borers.  

PRESERVATIVE TREATMENT

The LRM is generally resistant to preservative impregnation.

TEXTURE

Texture is coarse but even, with interlocked grain.

STRENGTH PROPERTIES

The timber falls into Strength Group C (Engku, 1988b) or SG 6 (MS 544:Part 2:2001).

Strength Properties of LRM 

Species Test Condition

Modulus of

Elasticity (MPa)

Modulus of

Rupture (MPa)

Compression parallel to grain (MPa)

Compression perpendicular to grain (MPa)

Shear strength

(MPa)

Page 1 of 4MTC Wood Wizard

1/23/2013http://woodwizard.mtc.com.my:8888/report.asp?AttrID=82&ItemID=76

Page 2: meranti properties

MACHINING PROPERTIES

It is easy to saw and work and gives a smooth planed surface.

Machining Properties of LRM 

NAILING PROPERTY

The nailing property of most species tested is good, except for S. hemsleyana, which is rated as poor.

AIR DRYING

The seasoning properties of some species tested are summarised below:

KILN-DRYING

Kiln Schedule F is recommended. The timber dries rapidly without degrade. 25 mm thick boards take about 6 days to kiln-dry from 50 to 10% moisture content, while 50 mm thick boards will require about 20 days.

Kiln Schedule F

S. acuminata

Green 10,500 54 27.4 2.41 6.3

S. hemsleyana

Green 13,200 68 37.0 - 7.7 Air dry 13,400 77 42.7 - 11.0

S. leprosula

Green 11,400 53 29.0 2.39 6.4 Air dry 13,600 75 41.4 2.51 6.8

S. parvifolia

Green 9,300 50 25.6 2.00 5.9 Air dry 10,200 63 34.5 2.41 6.5

Species Test Condition

Sawing Planing Boring Turning Re-

sawing Cross

Cutting Ease of planing

Quality of finish

Ease of

boring

Quality of finish

Ease of turning

Quality of finish

S. acuminata Green easy easy easy smooth easy smooth - - Air dry easy easy easy smooth easy smooth easy moderately

smooth S. hemsleyana Green easy easy easy smooth easy smooth - -

Air dry easy easy easy smooth easy rough easy smooth S. leprosula Green easy easy easy smooth easy smooth - -

Air dry easy easy easy smooth easy moderately smooth

easy moderately smooth

S. parvifolia Green easy easy easy smooth easy rough - - Air dry easy easy easy smooth easy rough easy moderately

smooth S. teysmanniana

Green easy easy easy moderately smooth

easy smooth - -

Air dry easy easy easy smooth easy smooth easy smooth

Species Time to air dry (months) Remarks 13 mm

thick boards 25 mm

thick boards 38 mm

thick boards S. hemsleyana 2.5 - 5 Moderately slow drying;

free from all seasoning defects.

S. leprosula 2 3.5 4 Fairly fast drying; free from seasoning defects.

S. parvifolia 2 3.5 4 Fairly fast drying; free from seasoning defects.

S. teysmanniana

- 4.5 - Moderately slow drying; slight bowing and twist.

Moisture Content (%)

Temperature (Dry Bulb)

Temperature (Wet Bulb)

Relative Humidity

(%) (approx.) ° F ° C ° F ° C

Green 120 48.5 111 44.0 75

60 120 48.5 109 43.0 70

Page 2 of 4MTC Wood Wizard

1/23/2013http://woodwizard.mtc.com.my:8888/report.asp?AttrID=82&ItemID=76

Page 3: meranti properties

SHRINKAGE

The shrinkage of some species tested are summarised below: 

DEFECTS

The presence of brittle heart is more severe and wide spread in LRM than in dark red meranti. The defect is often accompanied by advanced stages of rot resulting in hollow cores in old and over-matured trees. It can be readily identified on the sawn end of the affected part, which is rough and irregular in outline. The frequent transverse fracture of the fibre on the sawn surface is further evidence of its presence. LRM timbers are liable to attack by 'shot-hole' and 'pin-hole' beetles and in some cases it can be quite severe.

USES

The timber is very popular as a general utility timber, being suitable for furniture, interior finishing, panelling, partitioning, mouldings, skirtings, decorative works, joinery, shop and office fittings, staircase (angle blocks, rough brackets, baluster, balustrade, handrail and sprandrel framing), flooring, decking, posts, beams, joists, rafters, door and window frames and sills, pallets (expendable type), tool handles (non-impact), vehicle bodies (planking), ship and boat building (general planking), ornamental items, cooling tower (non-structural members), plywood and light construction works.

REFERENCES

1. Anon. 1975. The Natural Durability Classification of Timber. Tech. Note No. 40, Princess Risborough Lab., U.K.

2. Burgess, P. F. 1966. Timbers of Sabah. Sabah For. Rec. No. 6. 3. Choo, K. T. & Lim, S. C. 1983. Malaysian Timbers - Light Red Meranti.

Malaysian Forest Service Trade Leaflet No. 75. The Malaysian Timber Industry Board and Forest Research Institute Malaysia, Kuala Lumpur. 11 pp.

4. Engku Abdul Rahman Chik. 1998b. Basic and Grade Stresses for Strength Groups of Malaysian Timbers. Malayan Forest ServiceTrade Leaflet No. 38. The Malaysian Timber Industry Board and Forest Research Institute Malaysia, Kuala Lumpur. 13 pp.

5. Jackson, W. F. 1965. The Durability of Malayan Timbers. Mal. For. Ser. Trade Leaflet No. 28.

6. Menon, K. D. 1957. Susceptibility of Commercial Species of Malayan Timbers to Powder-post Beetle Attack. Mal. For. Ser. Trade Leaflet No. 27.

7. Menon, P. K. B. 1986. Uses of Some Malaysian Timbers. Revised by Lim, S. C. Timber Trade Leaflet No. 31. The Malaysian Timber Industry Board and Forest Research Institute Malaysia, Kuala Lumpur. 48 pp.

8. Mohd. Dahlan Jantan & Tam, M. K. Natural Durability of Some Malaysian Timbers by Stake Tests. In press.

9. MS 544:Part 2:2001. Code of Practice for the Structural Use of Timber: Permissible Stress Design of Solid Timber.

10. Wong, T. M. 1982. A Dictionary of Malaysian Timbers. Revised by Lim, S. C. & Chung, R. C. K. Malayan Forest Records No. 30. Forest Research Institute Malaysia, Kuala Lumpur. 201 pp.

40 125 51.5 109 43.0 60

30 130 54.5 109 43.0 50

25 140 60.0 115 46.0 45

20 155 68.0 124 51.0 40

10 170 76.5 136 58.0 40

Species       Shrinkage (%)     (Green to air dry)

Remarks

Radial Tangential

S. hemsleyana 1.9 5.4 High shrinkage, especially in the tangential direction.

S. leprosula 2.1 5 High shrinkage, especially in the tangential direction.

S. parvifolia 1.5 4.8 High shrinkage, especially in the tangential direction.

S. teysmanniana 1.6 7.4 Very high tangential shrinkage.

Page 3 of 4MTC Wood Wizard

1/23/2013http://woodwizard.mtc.com.my:8888/report.asp?AttrID=82&ItemID=76

Page 4: meranti properties

 

    MTC Wood Wizard

 

     

If you have any queries about MTC Wood Wizard, please write to [email protected] Copyright 2006 Malaysian Timber Council 18th Floor Menara PGRM, 8 Jalan Pudu Ulu, Cheras 56100 Kuala Lumpur, Malaysia Tel: +603-9281 1999 Fax: +603-9282 8999

Page 4 of 4MTC Wood Wizard

1/23/2013http://woodwizard.mtc.com.my:8888/report.asp?AttrID=82&ItemID=76