MEMB113 Engineering Graphics & CAE Semester 1 2015/2016

ASSIGNMENT 6: Manual Drawing - Isometric

Set A You are required to produce isometric drawing, with full dimensions, of the following object by using

manual drawing techniques on A2-sized paper with UNITEN standard drawing layout. All

dimensions are in mm. Please submit the drawing by 28th August 2015.

Figure 1. Rod bracket made of inconel.

MEMB113 Engineering Graphics & CAE Semester 1 2015/2016

ASSIGNMENT 6: Manual Drawing - Isometric

Set B You are required to produce isometric drawing, with full dimensions, of the following object by using

manual drawing techniques on A2-sized paper with UNITEN standard drawing layout. All

dimensions are in mm. Please submit the drawing by 28th August 2015.

Figure 2. Bracket made of cast iron.

MEMB113 Engineering Graphics & CAE Semester 1 2015/2016

ASSIGNMENT 6: Manual Drawing - Isometric

Set C You are required to produce isometric drawing, with full dimensions, of the following object by using

manual drawing techniques on A2-sized paper with UNITEN standard drawing layout. All

dimensions are in mm. Please submit the drawing by 28th August 2015.

Figure 3. Sleeve bracket made of hastelloy.