Material data sheet for plastic parts

MA

TERI

AL

DA

TA S

HEE

T PL

AST

IC P

ART

S

ADVANTAGES OF PLASTIC MODELS

Model sizes up to 1,000 x 600 x 500 mm (LxWxH)

up to 600 dpi print resolution

Same handling as for conventional wax parts after waxinfiltration

Noshellcrackingduetonegativecoefficientofthermal expansion.

Suitable for autoclaves, even for thin-walled shells Low residual ash content No heat distortion as hardening process is purely

a chemical process Coloureddisplaymodelsthroughepoxyinfiltration

PLASTIC Base material Binder - type Tensile strength Yield point Burn - out temperature Residual ash content Especially suitable for Advantages

PMMA particulate material (55 µm)Polypor B (PPB)4.3 MPa1 %700 °C< 0.3 % weightinvestment casting; design modelssharp edges; for highest accuracy and true-to-detail; reusable particle material

PMMA particulate material (85 µm)Polypor C (PPC)3.7 MPa1 %600 °C< 0.02 % weightinvestment casting; architectural modelsburns out well with practically no residual ash content; reusable particle material

TECHNICAL DATA PLASTIC PARTS Layer thickness Resolution x, y Accuracy

Standard 150 µmup to 600 dpi+ 0.3 % (+ 0.3 mm)

SUITABLE FINISHING TREATMENT

Tensile strength Softening temperature Burn-out temperature Characteristics

Epoxy up to 25 MPa80 °C–solid material,dyeable

Waxsee base material73 °Csee base materialsmooth liquid- resistent surface

Valid

ity:

09/2

016.

We

rese

rve

the

right

to m

ake

tech

nica

l cha

nges

. vo

xelje

t is

ISO

900

1- c

ertifi

ed.

voxeljet AG Paul - Lenz -Straße 1a 86316 Friedberg Germany Tel +49 821-7483 -100 Fax +49 821-7483 -111 info@voxeljet.com www.voxeljet.com

Americas EMEA AsiaPacific

Warranty/Disclaimer: The performance characteristics of these products may vary according to product application, operating conditions, material combined with, or with end use. voxeljet makes no warranties of any type, express or implied, including, but not limited to, the warranties of merchantability or fitness for aparticular use. ©voxeljet. All rights reserved. The designations voxeljet, VX200, VX500, VXC800, VX1000, VX2000 and VX4000 are registered trademarks of voxeljet AG. Specifications subject to change without notice.

Shrinking 0.7 - 1.0 %