Marley Leafslide

Rainwater Solutions

- Keep your drains clear of leaves!

®

Now available in Copper, Titanium, Grey Friars and Ironsand colours to match the Marley Stratus Design Series®

• Easy to install • Low maintenance • Improved water fl ow• Retains over 95% of water • Fits all Marley downpipes • UV stabilised

Positioning – The Leafl side is designed to be used with RP80® 80mm and RP65® 65mm Round Downpipe and Rectangular (65mm x 50mm and 100mm x 50mm) Downpipe. When installing a Leafslide in a wet system ensure it is installed above the maximum level of the water tank.

• If the Leafslide is being connected to a tank, the tank must be at least 300mm lower than the spouting (fi g 1) and the Leafslide must be above the inlet to the tank.

• Less splashing is observed when a vertical drop of the downpipe running into the Leafslide is 1.5 metres or less.

• The downpipe should be mounted fl ush with the back wall of the Leafslide body.

• Consideration should always be given as to where debris is discharged, eg. pathways and decks.

Installation – To install the Leafslide, you will need

– Screwdriver and screws – Downpipe Adaptors (if not using RP80® 80mm round downpipe) – RA65.80,

MC19.80 or MC141.80 – Marley MCS® solvent cement – Hacksaw – Ladder

1. Position the downpipe into the top of the Leafslide body, so there is at least 10–15mm of downpipe inside the Leafslide inlet. The further into the Leafslide the downpipe sits the better, making sure not to wedge the downpipe against the screen making it diffi cult to take out and clean.

2. Cut the downpipe on an angle matching the angle of the Leafslide screen to reduce splash–back and improve fl ow.

3. Screw the Leafslide to the wall or fascia using the screw holes at the back of the Leafslide body. The Leafslide may need spacers between the wall and the Leafslide depending on the type of wall and downpipe brackets.

4. The outlet of the Leafslide can be connected to RP80® 80mm round downpipe using Marley Solvent Cement (MCS), follow the Marley Solvent Cement Instructions in the Rainwater Installation Guide available at www.marley.co.nz. Use an adapter to connect to other size downpipes.

Maintenance – Routinely wash the fi lter screen, by lifting it out of the body and cleaning it. For an optimum performance of your leafslide, check regularly that there is no debris on the screen blocking the fl ow.

Product Guarantee – Screen: 5 years when adequately maintained. Body: 15 years.

The Marley Leafslide® works as a debris diverter and water fi lter for new or existing downpipes. Designed for small to medium sized homes experiencing average rainfall, it helps to stop leaves and other debris from entering into your tank or stormwater. The Leafslide is manufactured from UV stabilised PVC using a stainless steel mesh screen, it ensures over 95% of water is captured whilst diverting leaves and debris.

Accessories Sold Separately Insect-proof Leafslide Screen Sold separately for use where additional protection required against insects. NB. Finer mesh reduces fl ow capacity.

Replacement Leafslide Screen Standard mesh included with Marley Leafslide®. Also sold separately as replacement screen.

DESCRIPTIONCOLOUR / CODE

White Copper Titanium Grey Friars Ironsand

Marley Leafslide RWLS RWLS.COP RWLS.TTN RWLS.GYF RWLS.IRO

Replacement Leafslide Screen RWLS.SCREEN RWLS.SCREEN.COP RWLS.SCREEN.TTN RWLS.SCREEN.GYF RWLS.SCREEN.IRO

Insect-proof Leafslide Screen RWLS.INSECTSCREEN RWLS.INSECTSCREEN.COP RWLS.INSECTSCREEN.TTN RWLS.INSECTSCREEN.GYF RWLS.INSECTSCREEN.IRO

MAR

1679

Feb

201

5

Rainwater Solutions®

DISCLAIMERThis technical catalogue has been compiled by Marley New Zealand Limited (“The Company”) to promote better understanding of the technical aspects of the Company’s products to assist users in obtaining from them the best possible performance. The technical catalogue is supplied subject to acknowledgment of the following conditions:

The technical catalogue is protected by Copyright and may not be copied or reproduced in any form or by any means in whole or in part without prior consent in writing by the Company. Product specifications, usage data and advisory information may change from time to time with advances in research and field experience. The Company reserves the right to make such changes at any time without notice. Correct usage of the Company’s products involve engineering judgements which cannot be properly made without full knowledge of all the conditions pertaining to each specific installation. The Company expressly disclaims all and any liability to any person whether supplied with this publication or not in respect of anything and of the consequences of anything done or omitted to be done by any such person in reliance whether whole or partial upon the whole or any part of the contents of this publication. No offer to trade, nor any conditions of trading, are expressed or implied by the issue or content of this manual. Nothing herein shall override the Company’s Conditions of Sale, which may be obtained from the Registered Office or any Sales Office of the Company. This technical catalogue is and shall remain the property of the Company, and shall be surrendered on demand to the Company.

For more information: 0800 MARLEY (0800 627539) www.marley.co.nz