Upload
angin-a-camba
View
216
Download
0
Embed Size (px)
Citation preview
8/13/2019 Making a Closed Bed
1/1
Making A Closed Bed
1. Wash your hand and assemble equipment: 1 pillow case Pillow Spread sheet Blanket Top sheet Cloth draw sheet or half sheet Plastic or rubber draw sheet Bottom sheet
2. Elevate the head of the bed to acomfortable working height in a horizontal
position. Lock bed wheels so the bed will
not roll. Place a chair at the side of the bed.
3. Arrange the linen on the chair in order inwhich it is to be used
4. Place the bottom sheet on the bed andunfold it, seam side down and wide hem at
the top. The small hem should be brought
to the foot o the mattress. The center fold
should be at the center of the bed. If a
fitted bottom sheet is used, fit it smoothly
around one corner
5. Tuck sheet smoothly over the top of themattress. Make mitered corner.
6. Tuck in the sheet on one side, keeping thesheet straight. Work from the head to the
foot of the bed. If using a fitted sheet adjust
it over the head and bottom ends of the
mattress.
7. If used, place rubber draw sheet and clothdraw sheet with upper edge about 14
inches from the head of the mattress and
tuck under one side. Be sure that the cloth
draw sheet covers the rubber draw sheet. T
should cover the area above the patients
shoulders to below the hips
8. Unfold and place the top sheet on the bed,seam up, top hem even with the upper
edge of the mattress and the center fold in
the center of the bed
9. Spread the blanket over the top sheet andfoot of the mattress. Keep the blanket
centered
10.Tuck the top sheet and blanket under themattress at the foot of bed as far as the
center only
11.Place the spread sheet with its top hemeven with the head of the mattress. Unfold
the spread sheet to the foot of the bed
12.Tuck the spread sheet under the mattressat the foot of the bed and miter the corner.
13.Go to the other side of the bed. Fanfold thetop covers to the center of the bed so you
can work with the lower sheet and pads
14.Tuck the bottom sheet under the head ofthe mattress and miter the corner. Working
from top to bottom, smooth out all wrinkles
and tighten these sheets as much as
possible to provide comfort.
15.Grasp the rubber draw sheet and clothdraw sheet in the center. Tuck these sheets
under the mattress
16.Tuck in the tops sheet and the blanket atthe foot of the bed and miter the corner
17.Fold the top sheet back over the blanketmaking an 8-inch cuff
18.Tuck in the spread sheet at the foot of thebed and miter the corner. Bring the top of
the spread sheet to the head of the
mattress
19.Insert the pillow in the pillow case