Upload
sherman-griffin
View
220
Download
0
Embed Size (px)
Citation preview
Magnus Pro Training Magnus Pro Training PresentationPresentation
Image analysis SoftwareImage analysis Software
Note: The contents of this presentation are only showing the procedure for Note: The contents of this presentation are only showing the procedure for calibration, counting & generating reports. The dummy data have been calibration, counting & generating reports. The dummy data have been shown just for training purposeshown just for training purpose
CalibrationCalibration
• For any measurements calibration is required to be For any measurements calibration is required to be performed through standard stage micrometer. performed through standard stage micrometer.
• Formulae : Micrometer scale 1mm = 1000 MicronFormulae : Micrometer scale 1mm = 1000 Micron (e.g. 0.01mm= 10 micron)(e.g. 0.01mm= 10 micron)• It should be performed on all objectives of It should be performed on all objectives of
microscope where digital camera or MIPS are microscope where digital camera or MIPS are installed.installed.
• In case of readjustments or new replacement of In case of readjustments or new replacement of any part of microscope or camera, the calibration any part of microscope or camera, the calibration should be done again.should be done again.
(contd.)(contd.)
Select Magnification before Select Magnification before calibrationcalibration
Before going to Before going to measurement, one has to measurement, one has to
select appropriate select appropriate magnification of calibrationmagnification of calibration
• Focus stage micrometer under the first objective Focus stage micrometer under the first objective of microscope in X direction.of microscope in X direction.
• Capture image with proper names.Capture image with proper names.• Focus stage micrometer under the first objective Focus stage micrometer under the first objective
of microscope in Y direction.of microscope in Y direction.• Capture image with proper names.Capture image with proper names.• Repeat above procedure for any other objectives Repeat above procedure for any other objectives
like 10X, 40X, 100X etc. (as per availability)like 10X, 40X, 100X etc. (as per availability)
(contd.)(contd.)
Calibration Calibration (contd.)(contd.)procedureprocedure
Screen Dumps Screen Dumps (calibration)(calibration)
For objective 100X in X and Y For objective 100X in X and Y direction direction
Load image
captured in X
axis for 100X obj.
Move line slowly with the help of
Zoom Preview and release the line once it
reaches to the other line
Zoom Preview
If line is for e.g.. 60 pixels
Then write down same
reading in the Scale X value
Give the suitable name of calibration
and save
Calibration Procedure for X direction
Load image
captured in Y
axis for 100X obj.
Move line slowly with the help of
Zoom Preview and release the line once it
reaches to the other line
Zoom Preview
If line is for e.g.. 60 pixels
Then write down same
reading in the Scale Y value
Give the suitable name of calibration
and save
Calibration Procedure for Y direction
MeasurementMeasurement
• The measurements can be obtained The measurements can be obtained after pixel calibration.after pixel calibration.
• The units of measurements depends The units of measurements depends on the currently selected spatial on the currently selected spatial calibration (for e.g. micron or inches calibration (for e.g. micron or inches or millimeter etc.)or millimeter etc.)
Measurements of selected images
Images on which
measurements are calculated.
Selected calibration
CountCount
• Used to automatically identify Used to automatically identify objects in an image.objects in an image.
• To get the several feature of the To get the several feature of the measurements.measurements.
Automatically identified objects
in an image
obtained the several
features of the measurements
Click Count to count the no. of
objects
Automatic Report Automatic Report GenerationGeneration
Click Report data and select
appropriate data on which report is to
be generated
Select File for report to be generated