Model # 22-9906

Parts List

Qty Name

1 SD Cart Frame

2 MagLite Wheel

1 Tie-Down Strap Set

Holds up to 300 LBS

MagLite SD Cart

Tools Needed : Adjustable Wrench

1. With the cart upside down, remove lock nut

from axle, fold up inner wheel guard, and

insert axle through hole in the inner wheel

guard. Attach the lock nut to axle again while

holding black knob; tighten lock nut with

wrench.

2. Undo black knob from axle. Insert axle of

wheel through hole in the outer wheel guard.

Reattach black knob onto axle and tighten

completely.

3. Repeat other side then turn cart over and

push the kickstand in place.

4. Adjust padded cradle rests to the desired

width for the hull of your watercraft

(3 different adjustments). Once adjusted,

insert locking pin through hole and hook the

loop end over the pin to secure.

Customer Service:770-518-0045

Fax: 770-518-8507

Website: www.suspenz.com

Suspenz®, Inc.

8725 Roswell Road #0-220

Atlanta GA 30350

Rev. 11/16

Customer Service:770-518-0045

Fax: 770-518-8507

Website: www.suspenz.com

Suspenz®, Inc.

8725 Roswell Road #0-220

Atlanta GA 30350

or Visit Suspenz.com

“Video & Manual” page *QR code reader app required

Scan* to see Video Instructions for Assembly & Use

Customer Service:770-518-0045

Fax: 770-518-8507

Website: www.suspenz.com

Suspenz®, Inc.

8725 Roswell Road #0-220

Atlanta GA 30350

Suspenz® products are warrantied for life against defects in material or workmanship to the original owner. Product must

be used for its intended purpose under normal conditions. Please visit www.Suspenz.com for complete warranty

information.

OUR PLEDGE TO YOU

For Technical assistance or Replacement parts: call 866.787.7369

Page 2 MagLite SD Cart

Care

Rinse cart after each use to clean off sand, salt and

mud.

Caution

This cart is designed for hand towing only.

It is not intended to be pulled behind a bicycle or

motorized vehicle.

1. Center watercraft on cart with kickstand

down for balance.

2. Secure tie-down straps by hooking the “S”

shaped hooks on each side of the frame,

then tighten and pull strap until watercraft

is secure.

3. Release kickstand and away you go!

Visit www.Suspenz.com for additional

transportation and storage solutions.

Portable Boat Stand