Upload
bob-cook
View
218
Download
0
Embed Size (px)
Citation preview
www.goplextor.com
Serial ATA 6Gb/sSSD
The new Plextor SATA 6Gb/s SSD, the M3 Pro performance series, provides read/write speeds up to 540/450 MB/s in
sequential mode and up to 75,000/69,000 IOPS in random mode. The M3 Pro uses high-grade 24nm toggle flash, and
7mm height suitable for ultra-slim notebooks. The M3 Pro is Plextor’s third SSD release to feature exclusive firmware
with True Speed technology, which includes Plextor’s proprietary Bad Block Management, Global Wear Leveling, and
Instant Restore Technologies.
True Speed is designed to prevent drastic drops in read/write speeds that normally occur with SSDs after prolonged
use or when data becomes heavily fragmented. True Speed technology will maintain the M3 Pro’s high performance
and read/write speeds at like-new levels throughout the life of the drive.
Plextor strives to exceed industry standards with rigorous benchmark testing. Before leaving the factory, each Plextor
SSD is put through a 20-hour high temperature burn-in test and an intense simulation of real world environments. As a
result, Plextor SSDs have a 0.59% average annual failure rate, which is one of the lowest in the industry.
M3 Pro SSD uses the latest SATA 6Gb/s (SATA III) interface, Marvell’s server-grade controller chip, and Toshiba 24nm
Toggle NAND flash. Also supported by the flash is a 1.8V power mode, providing the M3 Pro with extremely low-power
consumption making it a very eco-friendly product.
The M3 Pro offers an affordable upgrade solution to transform your existing desktop or laptop into a high efficiency and
fast performance device. The M3 Pro is available in 128GB, 256GB, and 512GB capacities.
Never compromise.
2.5” Solid State Drive
PX-M3 Pro Series SATA 6Gb/s
Five-year Ironclad Warranty• Five-year ironclad warranty provides reassurance of Plextor’s high quality
standards
Highest Quality Components for Optimum Performance• Server-grade Marvell 88SS9174 controller chip for read/write speeds of up to
540MB/s and 450MB/s in sequential mode, and 75,000 and 69,000 IOPS for
random read/write operations at 4K file size
• The M3 Pro supports SATA 6Gb/s and is backward compatible with SATA
3Gb/s and SATA 1.5Gb/s
• The latest 24nm synchronous MLC NAND flash modules with Toggle mode
support from Toshiba further enhance product reliability
• The DDR3 DRAM cache transfers data faster and helps extend lifetime of the
product
Software & Accessory• Includes Disk Cloning & Backup Utility Software
• Includes 3.5” mounting bracket with screws
www.goplextor.comNever compromise.
Plextor 42000 Christy Street, Fremont, CA 94538www.goplextor.com
© 2012 Copyright Plexor LLC.Plextor Logo are registered trademark of Shinano Kabushiki KaishaOther brands and products are trademarks of their respective holdersContent subject to change without notices.
PX-M3 Pro Series SATA 6Gb/s
Form Factor and Connectors
Dimensions and Weight
Dimensions (W x H x D)
Weight
2.75 x 0.3 x 4.0 inch
1.94 ~ 3.53 oz
Form Factor
Power Connector
Data Connector
2.5-inch
15-pin SATA connector for DC 5V input
7-pin SATA connector
Drive
Software
Accessory
Literature
Plextor Solid State Drive
NTI Disk Cloning & Backup Utility
3.5” Mounting bracket with mounting screws
Quick installation guide
Users manual and warranty information
Package Contents
Performances
General Specification
Model
Capacity
Sequential Read (MB/s)
Sequential Write (MB/s)
Random Read (IOPS 4K)
Random Write (IOPS 4K)
BUFFER Memory (DDR3)
PX-128M3P
128GB
535
350
75,000
69,000
256MB
PX-256M3P
256GB
540
420
75,000
68,000
512MB
Power Consumption (Typical)
Temperature (Operating)
Temperature (Non-operating)
Shock
Vibration (Operating)
MTBF
Warranty
0.1W (Idle); 5W (Active)
32 ºF to 158 ºF (0 ºC to 70 ºC)
-40ºF to 185 ºF (-40 ºC to 85 ºC)
1,500G/0.5 ms
7~800Hz, 2.17G (RMS)
1.5 million hour
5 year
System Requirements (For Bundled Software)
CPU
Memory (RAM)
Interface
Operating System
Other
Pentium 4 1.3GHz and higher
512 MB RAM or higher
SATA (Serial ATA)
Microsoft Windows® 7
Microsoft Windows® Vista SP1
Microsoft Windows® XP SP3 / XP-Pro (x64) SP2
CD-RW/DVD-RW drive for bootable media creation
Internet connection recommended for updates
Microsoft Windows FamilyLinuxMac OS
UL, CE, BSMI, WHQL, RoHS
Supports TRIM, SMART, NCQ, ATA/ATAPI-8
Supported
SATA Revision 3.0 compliant,supports SATA 6/3/1.5 Gb/s
Supported
Operating System
Agency Approval
Command Set
Data Encryption
SATA Interface
Firmware Upgrade
Compatibility
PX-512M3P
512GB
535
450
56,000
34,000
512MB