30
SUMMER 2019 Saluting a Health Care Hero A publication for Staff and Physicians of IH Our mental health...It matters A true quality mindset Sparking conversations

LOW VOLTAGE MOTION SENSORS SWITCH · The human body is an infrared detection sensor switch controller, that use of infrared detection to turn on/off low voltage LED lighting (12/24VDC)

  • Upload
    others

  • View
    2

  • Download
    0

Embed Size (px)

Citation preview

Page 1: LOW VOLTAGE MOTION SENSORS SWITCH · The human body is an infrared detection sensor switch controller, that use of infrared detection to turn on/off low voltage LED lighting (12/24VDC)

LOW VOLTAGE MOTION SENSORS SWITCH Model: LN-SPIR-1CH

1-800-387-4081

ledworldlighting.com ledworld.ca |

LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA

Copyright © 2016 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).

Product SummaryThe human body is an infrared detection sensor switch controller, that use of infrared detection to turn on/off low voltage LED lighting (12/24VDC). As a person approaches the sensor within 16 feet (5M) area, the sensor acts as a switch to turn on the attached optional LED lighting. After the person leaves the sensor area, the unit will turn off automatically according to the set time delay.

Technical Specications

Voltage 12/24 VDC Class 2 regulated power source

Output 1 Channel

Detection Distance Area 5 meter (16.4ft)

Approach Angle 60 degrees

Output Current <5A

Time Delay 1-10min (adjustable)

Dimension L 76 x W 35 x H 34mm (2.99” x 1.37” x 1.33”)

Operating Enviroment -20°C~60°C (-4°F~140°F) Indoor use only (dry location).

Product Dimension

Interface SpecicationsPower input interface/ Load output interface

Direction for use

Ÿ Turn power off before connecting lighting or power source. Please carefully

check that the wire attached to the screw terminal are screwed in tight to avoid short circuit between connecting wires.

Ÿ Use the setting knob at the back of the controller to set the delay time

(1~10min) to turn off after a person is away from the area.

Ÿ The controller signal output line and input line should be connected with the

correct polarity and NOT exceed 5 amps.

76mm (2.99”)

35mm (1.37”)23mm (0.9”)

34m

m (

1.3

3”)

21m

m (

0.8

2”)

1

35

8

10

Output 12/24VDC Input 12/24VDC

-- ++

To 12/24VDC LED Fixture

Input 12/24VDC-+

-+

12/24VDC Class 2 Regulated Driver

120VAC 60Hz

Body Motion Sensing

LED Light Fixture

LED Light Fixture

Delay time setting control

Optional Connector Cord