Upload
junior-hunter
View
216
Download
1
Tags:
Embed Size (px)
Citation preview
Legacy Woodworking Machinery
Training session 2
Unique SpindlesLegacy conversational form
RopeBarley twistFlutingReeding
Smart ToolTurning without tool a library
Enable the macros
Setup for your system
Setup for your system
The Options
Turning RoundTurning Tool
ProfilesIndexingRope & Barley
Twist
SpiralsSurface PlaningLinear CutsTool list
Feed ratesTurning Round 150-250IPMTurning Tool Profiles 60-100IPMIndexing 200-300IPMRope and Barley Twist 150-
250IPMSpirals 150-250IPMSurface Planing 300-400IPMLinear Cuts 200-300IPM
The larger the bit the slower the feed rate
Spindle SpeedSpindle speeds are by router bit
diameter0-.5 inches 34000RPM.5-1 inch 24000RPM1-2 inches 19000RPM2-2.5 inches 16000RPM2.5-3 inches 12000RPM
Turning RoundThis is used as the first step for all round
spindlesTwo options when turning round
SideBottom
Side uses a two-flute strait cutting bitBottom uses a bottom cleaning bitThe speeds and feeds are different for both
The Side optionRecommend using a ½ cutterStep over is between 0.1 and 0.05Feed rate is 20-50 IPMThis is used when making small mortis and
tenon
The Bottom Option1.25 CutterUsed for roughing stock and tapering
materialStep over is between 0.5 and 0.125Feed rate is 150-250 IPM
Turning Tool ProfilesThis program uses router bit profiles to turn
shapes into your spindleImportant things to know
Spindle speedWhich side to climb millFeed Rate
IndexingThis program is used for fluting and reedingImportant things to know
Number of flutesStart and end pointsFeed Rate
Rope and Barley TwistImportant things to know
Direction of the spiralFinished diameterCutting depthStart and finish positionsRouter bit Diameter
SpiralsSlightly different than Rope and Barley twistThe differences
Router bit diameter vs. Spiral pitchCutting depth is very important
Surface PlaningPlaning burled wood
Climb mills for the best cutNo tear out0,0 point is the lower left corner
Linear CutsThis is for fluting or reeding on flat stock 0,0 point is the lower left corner