laboratory & sterilization technology

BM SERIESCirculated Water Baths

• Designed for many general and special applications in microbiology, research and industrial laboratories• Powerful circulation by means of the reliable pump replaced outside of the tank for excellent temperature homogeneity , ± 0,1°C @ 37°C and stability , ± 0,01°C @ 37°C• User friendly, programmable, reliable and accurate PID microprocessor control system• Highly visible dual displays for temperature and time• Programmable delayed start function• Safety thermostat to prevent running without water and audible and visual alarms against over heating• Seamless corrosion resistant stainless steel tank for a longer life• Minimized risk of contamination by the rounded corners and smooth surfaces of the tank• Silicon sheet heaters surrounding the tank from three sides for uniform heating• Triple insulation consisting of glass wool, aluminium layer and air gap for high efficiency• Angled front panel to protect the controller from accidental water spillage• Efficient tank usage as there is no obstruction in the tank such as circulation pump or heater • Convenient drain for discharging the liquid in the tank quickly• Footprint almost equal to the tank dimensions to save valuable bench space.• Various type of racks and shelves for tubes and flasks

• Designed for many general and special applications in microbiology, research and industrial laboratories

• Excellent temperature control of liquid for uniform and stable temperatures

• User friendly, programmable, reliable and accurate PID microprocessor control system

• Highly visible dual displays for temperature and time

• Programmable delayed start function

• Safety thermostat to prevent running without water and audible and visual alarms against over heating

• Seamless corrosion resistant stainless steel tank for a longer life

• Minimized risk of contamination by the rounded corners and smooth surfaces of the tank

• Silicon sheet heaters surrounding the tank from three sides for uniform heating

• Triple insulation consisting of glass wool, aluminium layer and air gap for high efficiency

• Angled front panel to protect the controller from accidental water spillage

• Efficient tank usage as there is no obstruction in the tank such as circulation pump or heater

• Convenient drain for discharging the liquid in the tank quickly

• Footprint almost equal to the tank dimensions to save valuable bench space.

NB SERIESUnstirred Water Baths

BS 30Refrigerated

Water Bath

CAREFULLY DESIGNED BODY• Solvent resistant epoxy-polyester powder coated stainless steel outer body

• Easy to clean stainless steel chamber

• Efficient insulation consisting of high density injected polyurethane

• Excellent temperature uniformity and stability with powerful circulation system even at low temperatures

BS 30 Refrigerated Water Bath is designed to be used for various applications and tests performed between 0°C and 80°C with the power of N-Smart™ control system

BS 30 is used for bacteria and cell culture, coagulation tests, determination of coliforms, enzyme reactions and for many other applications in research and industrial laboratories. By means of the optional external circulation pump, BS 30 can be used as refrigerated and heating circulator to regulate the temperature of the external systems.

EFFECTIVE INSULATION AND COOLING• Protection against ambient air temperature fluctuations with high density injected polyurethane insulation material

• Proportional cooling and PID heating system

RELIABLE AND POWERFUL CONTROL SYSTEM : N-Smart™• BS 30 Refrigerated Water Bath are powered by N-Smart™ instrument management system which is based on microprocessor technology and it is designed to simplify operation and guarantee the safety of stored samples

• Maximum information - 4,3’’ colourful LCD display to follow easily operating parameters

• Versatile & easy use – Four context-sensitive function keys

• Secured run parameters and data - Password protected menu

• With 5 Language options: Turkish, English, French, Russian, Spanish

• Use your preferred language – Possibility of editing the text into any language using the Latin alphabet as option

• Immediate understanding - Icons make the operations easier

• Full traceability - Operating parameters tracked digitally or graphically against time

• Alarms clearly displayed - Red colour warns the user in case of any alarm condition

• Fault analysis speeds recovery - Detailed description of the failure with HELP menu

• Longer life, lower energy use - Screen saver decreases the brightness of the display

• Massive data storage - Internal memory stores the records up to ten years with one hour intervals, digitally and graphically

• Failure analysis support – Service staff can recall stored failure history

• More efficient servicing – Password protected service section for software updates, calibration and technical parameter setting

FULL TRACEABILITY AND SAFETY WITH OPTIONAL NuveCom™ COMMUNICATION UNIT• Data always available - Communication unit for traceability and remote access

• Secure data backup – Save parameters on memory stick connected to USB port

• Selectable data recording frequency - Set the recording intervals as 10 or 30 seconds, 1, 5, 30 or 60 minutes to store in a memory stick

• World-wide access - Ethernet port for internet connection

• Local area networking - Remote access via ethernet connection

• Get rapid support – Can send e-mails with the details of any failure

• Remote access and control – NüveCloser™ software to access N-Smart™. Get all the information remotely or control and programme your NÜVE product wherever you are.

• Fast corrective action - AlerText™ GSM alarm module can send the details of any alarm condition to up to 5 mobile phone numbers, including emergency service backup 7/24.

Phon

e Al

arm

AlerTextTM

ST 30Shaking Water Bath

• Designed for shaking a variety of tubes and containers for tissue culture studies, bacterial incubation, enzyme reaction and fermentation

• User friendly, programmable, reliable and accurate PID microprocessor control system

• Precise shaking speed ensured by microprocessor control system and induction motor

• Highly visible LED displays for temperature, time and shaking speed

• Programmable delayed start function

• Safety thermostat to prevent running without water and audible and visual alarm against over heating

• Seamless corrosion resistant stainless steel tank for a longer life

• Minimized risk of contamination by the rounded corners and smooth surfaces of the tank

• Silicon sheet heaters surrounding the tank from three sides for uniform heating

• Triple insulation consisting of glass wool, aluminium layer and air gap for high efficiency

• Angled front panel to protect the controller from accidental water spillage

• Convenient drain for discharging the liquid in the tank quickly

• Possibility to use different types of tubes, flasks or erlenmeyers with wide range of accessories

The Right Choice for the Right Results

Nüve, which was founded in 1968, is one of the leading and outstanding manufacturers ofTurkey in the field of laboratory and sterilization technology.

Since its foundation, Nüve had contributed to the advancement of its products and production processes by means of technical innovations and investments made for research and development.

With a network of 30 distributors in Turkey, Nüve holds the major part of the Turkish market. Strong international focusing; formulated, fast, economic solutions combined with continually evolving quality awareness and customer oriented services form a significant part of Nüve’s business concept. Because of these special features, Nüve has become a fast growing company among its competitors. Having ISO 9001:2008 and ISO 13485:2012 certificates, Nüve is exporting to more than 100 countries by the contribution of its professional work force and very competitive quality and price.

The manufacturing plant is 30 km away from Ankara, the capital city of Turkey and consists of 6000 m2 closed area. High technology machine tools and sheet metal working machines are used for standard production. The quality of the raw materials and parts supplied plays an important role in obtaining a stable production of high quality products.

The product range of Nüve is expanding every year proportional with its continuous research studies. Subject to ever-changing customer perceptions and worldwide technological improvements, also the development of products never ends at Nüve.

The equipment that Nüve manufacture are mostly used in all kinds of medical laboratories, biotechnology, research and quality control laboratories of agriculture, botany and veterinary as well as in the quality control laboratories of various industries such as food, beverage, dairy, chemicals and pharmaceuticals.

With its flexible mass production technology, fast delivery process, well established network ofnational and international distributors, quick and efficient after sales services and unlimited spare part supply, Nüve is ready to meet the needs and demands of its customers all times and just in time.

NÜVE SANAYİ MALZEMELERİ İMALAT VE TİCARET A.Ş.

nuve.com.tr sales@nuve.com.tr

Saracalar Mah. Saracalar Kümeevleri No: 4/2 Akyurt 06750 ANKARA / TURKEY t. +90 312 399 28 30 f. +90 312 399 21 97 10

.201

7/Z1

5.K

34 0

02