Audio before and after

Jordan Smith

This is the piece of audio before being edited.

This is the audio piece after editing.

The master volume is the general volume of the audio piece; it determines how the loud the audio sequence is.

The metronome adjusts the rhythm of the audio such as when you create a beat in a song and the metronome can then be adjusted to edit the beat timing.

In the local channels section, you will see a small sliding bar, this adjusts the overall volume, which practically does the exact same thing as the master volume setting.

The input option edits the audio sequence’s echo/repeat effect, the more the input is increased, the more the echo applies.

The rate option just sounds like increases the number of times the echo is repeated, it is a really subtle, and un-noticeable option.

The depth option isn’t really noticeable on its own, but if you turn it up and down with the mix option you can really notice the changes that have been applied to the audio sequence.

The mix option mixes with the depth option, it adjusts the echo on its own, but also helps deal with the deepness of the audio if it is used with the depth option.The size option makes the audio sound smaller or

bigger in a sense depending on how much the size has been adjusted, it makes it sound slightly more echo and sound more far away if the option is down, but if its turned up, then the audio sounds more crisp and louder.

The Hi and Lo options adjust the crisp quality of the audio sequence.