Innovative Technology . . . Solutions Pipe Vibration Provides: •Quick and Easy Application •No Downhole Intervention •Reduced Risk •Simplified Decision Making •Demonstrated Results * * * * * “To our knowledge, simultaneous recovery has never been attempted much less accomplished” notes Paul Moore, Vibra- tion Technology Service Manager, in Shreveport, LA. “We used our 85,000 pound load capacity oscillator and the job only took about 30 minutes to have every- thing free and started out of the hole.” On April 26, 2000, Vibration Technology’s proprietary equipment and methods made it possible to simultaneously recover a gravel pack screen and packer from a high capacity gas well located in South East Texas. The Halliburton gravel pack completion assembly consisted of a packer, sliding sleeve, shear release, blank and wire wrapped screen as illustrated in Figure 1. In South East Texas, as well as throughout the surrounding Louisiana-Texas Gulf Coast and Offshore Gulf of Mexico area, packer and screen recovery is somewhat of a routine maintenance procedure, normally done over the course of several days using either jarring or washover techniques. Conventional fishing can be tedious, time consuming, as well as costly and, as experienced oil industry personnel know full well, with each step of a procedure there is an inherent risk of something else going wrong, sometimes with catastrophic consequences. This 5,500 Ft. well had experienced a dramatic increase in sand production to the extent that immediate remedial procedures were required. The job was accomplished by leveraging the unique capacity of Vibration Technology’s mechanical oscillator to “fluidize” sand, turning it into a quasi liquid state that allows tubular goods to move freely through the gravel pack sand. Conventional fishing procedures were not required. The economics of this job proved favorable for the customer because of the elimination of three days (more or less) of various services and costs that are conventionally required. But the real story is that the well was back on production several days sooner than expected and without any “surprises” or contingencies that often have to be overcome. Been there, done that? Vibration Technology Oscillator Used For Gravel Pack Screen Recovery Figure 1. Simultaneous Packer and Screen Recovery Schematic Drawing Courtesy: Halliburton Energy Company Job Report Telephone: (432) 689-3351 Fax: (432) 689-3352 2319 E. CR 123 Midland, TX 79706 www.vibrationtechnology.com For more information on the application of pipe vibration in your oilfield situation, or for more detail about the technology’s principles, please call us.

Job Report - vibrationtechnology.comvibrationtechnology.com/pdf/NewPackerScreen.pdf · The Halliburton gravel pack completion assembly consisted of a packer, sliding sleeve, ... packer

Download PDF Report

Upload
buingoc
View
227
Download
1

Embed Size (px)

Citation preview

Page 1: Job Report - vibrationtechnology.comvibrationtechnology.com/pdf/NewPackerScreen.pdf · The Halliburton gravel pack completion assembly consisted of a packer, sliding sleeve, ... packer

Innovative Technology . . . Solutions

Pipe Vibration Provides:•Quick and Easy Application•No Downhole Intervention•Reduced Risk•Simplified Decision Making•Demonstrated Results

* * * * *

“To our knowledge, simultaneous recov-ery has never been attempted much lessaccomplished” notes Paul Moore, Vibra-tion Technology Service Manager, inShreveport, LA. “We used our 85,000pound load capacity oscillator and the jobonly took about 30 minutes to have every-thing free and started out of the hole.”

On April 26, 2000, Vibration Technology’s proprietary equipment and methods made it possible tosimultaneously recover a gravel pack screen and packer from a high capacity gas well located in South

East Texas. The Halliburton gravel pack completion assembly consisted of a packer, sliding sleeve,shear release, blank and wire wrapped screen as illustrated in Figure 1.

In South East Texas, as well as throughout the surrounding Louisiana-Texas Gulf Coast and OffshoreGulf of Mexico area, packer and screen recovery is somewhat of a routine maintenance procedure,normally done over the course of several days using either jarring or washover techniques.Conventional fishing can be tedious, time consuming, as well as costly and, as experienced oil industrypersonnel know full well, with each step of a procedure there is an inherent risk of something elsegoing wrong, sometimes with catastrophic consequences.

This 5,500 Ft. well had experienced a dramatic increase in sand production to the extent thatimmediate remedial procedures were required. The job was accomplished by leveraging the uniquecapacity of Vibration Technology’s mechanical oscillator to “fluidize” sand, turning it into a quasiliquid state that allows tubular goods to move freely through the gravel pack sand. Conventionalfishing procedures were not required.

The economics of this job proved favorable for the customer because of the elimination of three days(more or less) of various services and costs that are conventionally required. But the real story is thatthe well was back on production several days sooner than expected and without any “surprises” orcontingencies that often have to be overcome. Been there, done that?

Vibration Technology Oscillator Used ForGravel Pack Screen Recovery

Figure 1.

Simultaneous Packer and Screen Recovery

Schematic DrawingCourtesy:

Halliburton EnergyCompany

Job Report Telephone: (432) 689-3351Fax: (432) 689-3352

2319 E. CR 123Midland, TX 79706

www.vibrationtechnology.com

For more information on the application of pipe vibration in your oilfield situation, or for more detail

about the technology’s principles, please call us.