8
Jeti Cable Converting 9bit data to 8bit used by Snipe and Finch. Manual version: 1.0 RC Electronics support@rc-electronics. eu ; www.rc-electronics.eu

Jeti Cable - RC Electronics

  • Upload
    others

  • View
    6

  • Download
    0

Embed Size (px)

Citation preview

Page 1: Jeti Cable - RC Electronics

Jeti CableConverting 9bit data to 8bit used by Snipe and Finch.

Manual version: 1.0

RC Electronicssupport@rc-electronics. eu ; www.rc-electronics.eu

Page 2: Jeti Cable - RC Electronics

Contents

Introduction.................................................................................................................................................3Specifications...........................................................................................................................................3

How it install it............................................................................................................................................3ds-16........................................................................................................................................................3dc-24........................................................................................................................................................5

Revision history..........................................................................................................................................6

Jeti Cable Page 2

Page 3: Jeti Cable - RC Electronics

Introduction

The Jeti Cable is a converting cable needed to convert JetiEx 9bit serial data to 8bit serial data which isused in Snipe and Finch units. It has 3.5mm jack audio connector to which external cable is thenconnected , connecting Snipe / Finch unit with Jeti transmitter. Power is taken from Jeti transmitterbattery and power consumption is 5mA.

Specifications

Unit Dimensions 23 mm x 11 mm x 5 mm + cable on each sideWeight 3 grams

How it install it

User must enable JetiEX protocol output on internal PPM connector. To do it so please goto Jeti setupmenu → System →Configuration and set PPM Con. Settings to EX Data stream!

3.5mm audio connector can be installed in free switch hole or user must drill out on side / back platenew hole in order to install it.

Jeti Cable Page 3

Page 4: Jeti Cable - RC Electronics

ds-16

Jeti Cable Page 4

Page 5: Jeti Cable - RC Electronics

Jeti Cable Page 5

Page 6: Jeti Cable - RC Electronics

dc-24

Jeti Cable Page 6

Page 7: Jeti Cable - RC Electronics

Jeti Cable Page 7

Page 8: Jeti Cable - RC Electronics

Revision history

18.10.2019 v1.0 - initial release

Jeti Cable Page 8