ION CHAMBER INTRODUCTION TRANSITION - HANDOFF FROM EESIC
SESSION 1 21 SLIDES TOTAL OCT 12 2010 1
Slide 2
WHAT IS IT? A MEANS OF PROTECTING VACUUM BEAMLINE HARDWARE IN
THE EVENT OF UNINTENDED BEAM / HARDWARE INTERACTION. 2
Slide 3
HOW DOES IT PROTECT? TRIGGERS THE FSD SYSTEM WHEN THE ION
CHAMBERS OUTPUT EXCEED THE ADJUSTABLE (REMOTELY) TRIP LEVEL 3
Slide 4
WHERE IS THS SYSTEM INSTALLED? HALL A AND HALL C ELECTRONICS
CABINETS 1/HALL IS THE PRIMARY CENTRAL COMPONENT. LOCATED IN THE
LABYRYNTH ( WITHIN THE HALL BUT OUTSIDE RADIATION ZONE) 4
Slide 5
TYPICAL CHAMBER INSTALLATION SW CORNER OF HALL C PIVOT PLATFORM
5
Slide 6
SCATTERING CHAMBER LOCATION 6
Slide 7
WHAT IS IN THE CABINET? PLC CONTROLLER, ASSOCIATED I/O MODULES,
UPS, 5VPS, 24VPS GRAPHICAL TOUCH SCREEN ON DOOR INTERFACE BOARDS.
1/ION CHAMBER SPARE COMPONENTS 7
Slide 8
INSIDE VIEW OF CABINET HALLS A AND C ARE SIMILAR NOTE 8
CHANNELS MAXIMUM 8
Slide 9
CABINET EXTERIOR GRAPHICAL TOUCH SCREEN CABLES TO BLACK BOXES
NETWORK/ COMMUNICATIONS 9
Slide 10
LOCAL CONTROL / TESTING 10
Slide 11
PLC RAIL 11
Slide 12
POWER SUPPLIES 12
Slide 13
PURPOSE OF THE BLACK BOX TRANSITION BETWEEN THE ELECTRONICS
CABINET INTERFACE CABLES (1/CHAMBER) AND THE ION CHAMBERS SHV AND
BNC CONNECTORS TO/FROM CHAMBERS TRIM TRIO FOR 3PR CABLE PCB HAS
CONVERTOR. 5v IN => 500V OUT 13
Slide 14
BLACK BOX 14
Slide 15
15
Slide 16
INTERFACE BOARD TEST CMD INPUT RANGE SELECT, OUTPUTS SIGNAL
FROM CHAMBER. NOTE SERIES RESISTOR LOW VOLTAGE INPUT 16
Slide 17
17
Slide 18
MCC SCREENS ACCESS FROM EDM RADCON => HALL C ION CHAMBERS
18
Slide 19
1 ST SCREEN 19
Slide 20
EXPERT SCREEN 20
Slide 21
AUTO SCREEN ALL CHAMBER TRIP LEVELS CAN BE PRESET FOR VARIOUS
TARGETS AND BEAM PARAMETERS 21
