INTRODUCTION TOSURFACE WELL CONTROL EQUIPMENTThorough knowledge of the BOP and related well control equipment is vital for safe, effi cient and trouble-free drilling, completion and well intervention.

WELL CONTROL SOLUTIONSWWW.WELL-CONTROL.COM.AU

SALES@WELL-CONTROL.COM.AU

07 3375 438824 ENTERPRISE ST, RICHLANDS

YOUR LOCALWELL CONTROL SERVICE CENTER

SPECIALISTSIN WELLCONTROL

Well control systems and blow out preventors are critical safety equipment. That’s why we are specialists at what we do.

HUGE STOCKSAVES TIMEAND COST

With a massive range of spares and equipment in stock, you now have a reliable parts supply close to home.

WE SELL, REPAIR AND SERVICE

We’re Australian Agents and specialists in pressure control equipment.

The introduction to Surface Well Control Equipment workshop presents the BOP and related well control equipment found on today’s surface rigs.

This highly informative workshop equips candidates with overall knowledge of drilling equipment, explains the most common faults of BOP’s on surface rigs and introduces basic maintenance procedures with a focus on safe working practices. The course compliments the skills gained during the mandatory IWCF well control training.

Who Should attend?This workshop is aimed at the following individuals working on land rigs, platform rigs, barge rigs and jack-up rigs.– roughnecks– derrickmen– (assistant) drillers– toolpushers– drilling supervisors– maintenance supervisors– rig managers– HSE staff– (assistant) mechanics– drilling engineers

Function and pressure testing of the BOP HPU.Dismantle and assembly of ram and annular preventers.

WELL CONTROL SOLUTIONSWWW.WELL-CONTROL.COM.AU

SALES@WELL-CONTROL.COM.AU

07 3375 438824 ENTERPRISE ST, RICHLANDS

“Verification of competency in

use of well control equipment is a requirement by

clients, regulators and contractors”

StructureThe workshop consists of interactive sessions and practical assignments under supervision of Well Control Solutions staff at their facility in Brisbane.

DurationTwo days dedicated time in WCS workshop

Why Well Control Solutions?We provide an extensive range of pressure, flow and well control equipment .With global manufacturing presence and emphasis on service. We are able to deliver high quality cost effective solutions, training and competency verification for our clients. Our expert customer focus, assured safety, quality, reliability and the dependable service are the keys to our repeated success.

The verification of competencies in regard to well control equipment is essential for crews as a refresher and to give them confidence they are capable of operating the equipment safely

Aims of the courseUpon completion of the course attendees will be confident that they are competent to operate maintain and understand the functioning of surface well control equipment as follows

Workshop ContentPractical experiences covered during the workshopFunction, operation, inspection and most common problems on • Ram preventers• Annular preventers• Gate valves• Choke/kill manifolds• Hydraulic control units• Remove and install ram preventer blocks• Remove and install annular preventer element• Adjust settings on BOP Hydraulic unit.

• Carry out pressure test on a BOP surface stack including rams, annular, choke and kill manifold.

• Compete theoretical exam at end of the workshop

This informative workshop verifies that crews have the theoretical knowledge and practical ability to carry out the required tasks in the operation of well control equipment

Explain the theory behind the operation of well control equipment• Remove and install the ram preventer blocks• Remove and install annular preventer element/bladder.• Remove and install a gate valve in a choke or kill manifold• Carry out a BOP test on rams, annular, choke/kill manifold

and gate valves

It is not intended for this workshop to replace any mandatory IWCF or other well control training, rather it is designed to complement this mandatory training and verify the crews are competent between attending other well control courses