15
Engines Four-Stroke Gasoline Engine wo-Stroke Gasoline Engines iesel Engine otary Engine team Engine ernal combustion engine needs l, ignition and compression order to run.

Internal Combution Engines

  • Upload
    sudip

  • View
    225

  • Download
    0

Embed Size (px)

DESCRIPTION

Internal Combution Engines

Citation preview

Page 1: Internal Combution Engines

Engines

• Four-Stroke Gasoline Engine

•Two-Stroke Gasoline Engines

•Diesel Engine

•Rotary Engine

•Steam Engine

Internal combustion engine needsfuel, ignition and compression in order to run.

Page 2: Internal Combution Engines

EnginesConfiguration

• Inline Engines: The cylinders are arranged in a line, in a single bank.

• V Engines: The cylinders are arranged in two banks, set at an angle to one another.

• Flat Engines: The cylinders are arranged in two banks on opposite sides of the engine

Page 3: Internal Combution Engines

EnginesParts

•Exhaust Valve lets the exhaust gases escape the combustion Chamber. (Diameter is smaller then Intake valve)

•Intake Valve lets the air or air fuel mixture to enter the combustion chamber. (Diameter is larger than the exhaust valve)

Valves: Minimum Two Valves pre Cylinder

Page 5: Internal Combution Engines

Engines

Different arrangement of valve and camshaft.

Page 6: Internal Combution Engines

Engines

Cam Shaft: The shaft that has intake andExhaust cams for operating the valves.

Cam Lobe: Changes rotary motioninto reciprocating motion.

Page 7: Internal Combution Engines

Engines

It provides the means of ignition when the gasoline engine’s piston is at the endof compression stroke, close to Top Dead Center(TDC)

Spark Plug

The difference between a "hot" and a "cold" sparkplug is that the ceramic tipis longer on the hotter plug.

Page 8: Internal Combution Engines

EnginesPiston

A movable part fitted into a cylinder, which can receive andtransmit power.

Through connecting rod, forcesthe crank shaft to rotate.

Page 9: Internal Combution Engines

EnginesCylinder head

Part that covers and encloses theCylinder.

It contains cooling fins or water jacketsand the valves.

Some engines contains the cam shaftin the cylinder head.

Page 10: Internal Combution Engines

EnginesEngine Block

Foundation of the engine and contains pistons, crank shaft,cylinders, timing sprockets and sometimes the cam shaft.

Page 11: Internal Combution Engines

Engines

Connecting (conn.) Rod

Attaches piston (wrist-pin)to the crank shaft (conn. rodcaps).

Page 12: Internal Combution Engines

EnginesCrank Shaft

Converts up and down motion into circular motion.Transmits the power to transmission.

DAMPNER PULLEYControls Vibration

Page 13: Internal Combution Engines

EnginesPiston Rings

Four stroke: Three ringsTop two are compression rings (sealingthe compression pressure in the cylinder)and the third is an oil ring (scrapesexcessive oil from the cylinder walls)

Two Stroke: Two RingsBoth the rings are Compression rings.

Page 14: Internal Combution Engines

Engines

Flywheel

Attached to the crankshaft

Reduces vibration

Cools the engine (air cooled)

Used during initial start-up

Transfers power from engine to Drivetrain

Helps glide through strokes

Page 15: Internal Combution Engines

Engines