Sheet1
How to Install the Power Logger
Firstly, We should disconnect the power source from the 100 A
Panel and connect the power logger cables into the GEDP as shownYou
Should terminate the cable in the GEDP using a suitable
terminalCheck on the Power Logger batteries Connect the Power
Logger adapter to the SocketTurn On the Power Logger from the Power
buttonPower Logger starts everytime with single phase wiring - So
at the three phases measurement, press on the wiring button three
times1P2W mode at single phase measurement
Press on Wiring Buttom three times to activate three phases
measurement
Three phases mode activated3P4W mode at 3 phases measurement
Three phases readings - Volt and Ampere
We have to adjust the date and time - press Set button and
adjust the date, time as FollowUse the Up-down-Left-Right buttoms
and enter Buttom to adjust the timeTimeMinutesYear 13Seconds
06Month 12Day 03Hour 13Press set again and adjust the interval -
the prefarred interval is 30 seconds or one MinuteAfter That, press
on Start button - you should see M inside a square appears on the
screenYou will see M inside a square appears on the screen - It
means that the Power Logger is saving the readings into its
memoryLeave the Power Logger opened in the site after calling the
SOC teamConnect the power Logger to the Labtop using the USB to
Serial Cableadjust the Com of the USB to serial to be the same as
the Power Logger ComThe Software opening as followOpen Data Logger
as indicates belowTo erase what recorded in the power logger memory
click on EraseTo get the data stored in the power logger, click on
the set you want to getThe counter will count till reach 100% After
the counter reaches 100%, the below window appearsClick on SaveOpen
empty Excel sheet and open the file you saved and follow the b/m
captutes
MDouble click here if you want to get the data you saved
before
Sheet2
Sheet3
