Upload
dohanh
View
223
Download
2
Embed Size (px)
Citation preview
23.03.2018
WOOPIES – acoustic panels made of swisswoolInstallation – wall and ceiling
Installation instructions for wall and ceiling panels (W1)
Step 3
Insert plugs
Step 2
Drill the holes
With absorber plateStep 5A
Push in the absorber plate behind the magnetic discs
Step 1
Mark the drill holes using the drill-hole template
Step 4AWith absorber plate
Insert the spacer tube between the wall and magnetic disc
With absorber plateStep 6A
Place the panels on the magnetic discs
Step 5B
Place the panels on the magnetic discs
Without absorber plateWithout absorber plate
Attach the magnetic discs
Step 4B The installation of small panels (600mmx600mm) is shown as an example.
The installation of other formats with several � xing points is carried out in the same way.
The quantity of absorber plates may vary depending on the panel size.
23.03.2018
WOOPIES – acoustic panels made of swisswoolInstallation – ceiling
Installation instructions for � oating ceiling sails (W2)
Run the wire cable through the screw cap and screw into the ceiling fastener
Step 5
Step 3
Insert plugs
Step 2
Make drill holes in the ceiling
Step 8
Cut the wire cable to the required length
Step 1
Mark the drill holes in the ceiling
Step 4
Fix the ceiling fastener to the ceiling
Step 7
Run the wire cable through the gripper and screw in
Screw gripper-fastener to the panel
Step 6
Hold down the guide bush to adjust the height of the ceiling sails
Step 9
23.03.2018
WOOPIES – acoustic panels made of swisswool
Hold down the guide bush to adjust the height of the panel
Push the wire cable through the bush into the panel and run it through completely
Installation – space
Installation instructions for suspended room divider (W7)
Step 3
Insert plugs
Step 2
Make drill holes in the ceiling
Step 5
Run the wire cable through the screw cap and screw into the ceiling fastener
Step 1
Mark the drill holes in the ceiling
Step 4
Fix the ceiling fastener to the ceiling
* Repeat steps 6, 7 and 8 depending on the number of panels
Step 6*
Push the guide bush into the marked holes
Step 7* Step 8*
Shorten the wire cable to the required length, or attach a furtherpanel
Step 9