8/8/2019 Installation Made Easy

http://slidepdf.com/reader/full/installation-made-easy 1/2

Necessary Tools:Low-tack masking tape—for positioning Camowraps® in placeFelt-tipped squeegee—for applying the graphicHobby knife (OLFA or XACTO knife)—for trimming away excess vinylAir release tool—for removing air bubbleRivet brush—for installation over rivetsHeat gun—for heating the vinyl on complicated applications

Before Application:1. First of all, you’ll need to wash the whole exterior of your vehicle removing all loose dirt, grime or road fihat could pose as an obstruction to you while you’re installing Camowraps® . Mirrors, moldings, handles, locks, emblemhat you’ve stuck to the vehicle can be removed but not necessary for installation.

2. For best results use 70% Isopropyl Alcohol as a final wipe before installation. If there is any stubborn residuse a bug and tar remover but remember to come back and wipe with alcohol as the final step before installati

Installation:3. It is advisable for you to start the installation process at the rear of the vehicle workingorward overlapping each panel.

4. To ensure that you’ve got the size and placement correct, try placing Camowraps® against the panel to ensure that it fits just right. If it doesn’t, this is the time that youcan still make some minor changes so that it fits to your vehicle to the “T”. When you’re

absolutely sure that it’s in place then apply masking tape at top edge to hold in place.

8/8/2019 Installation Made Easy

http://slidepdf.com/reader/full/installation-made-easy 2/2

From the edge of the tape hinge, take off the back lining from your Camowraps® and slowly pull it downward applying miessure over the material slowly and gently. Squeegee the area from center outward,d left to right continuing downward. Along the way smooth out any wrinkles and bubblesat are visible.

It’s important that you should not attempt to stretch Camowraps® over areas that arerd to reach, body indentations or tight curves. This may result in tearing the material

cidentally. What you should do is lift Camowraps®

away from the panel and squeegee itmly into the recessed areas carefully.

Once you’re done trimming the material around any obstruction you can find, use an air release tool or pin ntly and then push all of the air out of the bubbles. Or you can opt to squeegee toward the puncture.

If you have to contend with lots of curves and dents when installing Camowraps® on your vehicle, use a heat gun or hair plicator brush to work out the wrinkles and bunches. Remember to apply low temperature only. Just heat it slat source several inches away from the material and smooth Camowraps® over your vehicle panels.

When making relief cuts for contoured edges and curves cut slits at the edge of theaterial and overlap them so that one piece covers the other. The pieces should normally erlap at least ¼ inch to ensure proper coverage. Press the edges together firmly withur fingers and apply slight heat.

. Once you have completed the installation check and see if there are any air bubbles,rinkles or areas that need further attention. If there are, use firm pressure and heaten squeegee or brush out areas until smooth.

you’re satisfied with your work, reinstall all obstructions that you’ve earlier removed.