Upload
others
View
166
Download
12
Embed Size (px)
Citation preview
1
Install & Set ARH Combo Smart - RFID Passport Reader Driver
Virgo Technical Support team welcomes all inquiries and is ready to provide free technical support to install and set the reader, through direct access to technical support:
https://goo.gl/LHzPd2
To download e-Passport reader’s driver, follow this link and choose ARH Drivers as shown
http://atss.arh.hu/UploadsSite/Get.aspx?ID=c8a52538-1282-4fa6-b91f-fd19c74b1133
Also, ARH Combo Scan We follow the following steps for the reader:
- Open download folder and run setup file
2
Note: If your windows system type is 64Bit operating system, you must install 32Bit version and 64Bit version in addition to install SmartCard driver
12
Note after installation complete, plug-out & plug-in the reader from electricity
To prepare ARH reader within Virgo Offline, there are two ways:
- Method 1: Choose an Internal Reader Application
If you don't use the slide feature RFID, we enter the System settings from Others menu or directly from the main window,and from General tab we choose passport reader as ARH ComboSmart, then we choose Internal Reader Application and click OK
14
- Method 2: Choose an External Reader Application
If you use the slide feature RFID, we enter the System settings from Others menu or directly from the main window,and from General tab we choose passport reader as ARH ComboSmart, then we choose External Reader Application and click OK
15
When running a Virgo Offline, the ARH Reader application is run automatically
Select pictures path if you want to change it, Where it's be by default same as the Picture Path of the Virgo Offline system D:\Virgo\VirgoOffline1438\Photos
NOTE: You must make sure Reader mode: ARH PRMC
If the connecting process succeeds and the reader works correctly, "No Document" phrase will appear at the bottom of ARH Reader application.
Note: If "No Document" phrase didn't appear, you must close the Virgo Online system and restart it and read the passports again.