8/12/2019 Ins_r4r6

1/2

6

Lead the motor and mains cables through the

bottom plate.

ENSURE MAINS SUPPLY TO INSTALLATION IS OFF.

LOCK THE DISCONNECTOR TO OPEN POSITION.ACx 600 MUST BE INSTALLED BY A COMPETENT PERSON.IF IN DOUBT DO NOT INSTALL.

1

1. Measure the places for four screw holes.

Mark the hole positions. 2. Drill the holes.

3. Screw in the screws.

2

Position ACx 600 onto screws and securelytighten in all four corners. Note: Lift ACx 600

by its chassis, not by its cover.

1. Remove the Control Panel. 2. Remove thetelephone connector of the Panel. 3. Remove

the cover.

STOP

FOR

INSTALLATION

OF OPTIONAL

EQUIPMENT, SEE

SEPARATE

INSTRUCTIONS

INCLUDED IN

THE DELIVERY.

4 5

1. Strip off the insulation from the motor cable

and mains cable. Twist the screen wires to

bundles. 2. Make suitable holes to motor and

mains cable grommets.

Before Starting Installation

CHECK BOX CONTENTS: ACx 601, Manual(s), Testing report, Ordered options, Quick Guide(s)

CHECK INSTALLATION SITE AMBIENT CONDITIONS: See Manual.

CHECK INSTALLATION SPACE: ACx 600 free space requirements are 300 mm above and below, 50 mm on the left and on the right.

CHECK INSTALLATION SURFACE: Vertical, smooth and solid, free from heat, damp and condensation.

CHECK ACCESSORIES NEEDED: See Manual for fuse, supply disconnecting device and cable specifications.

3

Mains cable

OUTPUT

STOP

CHECK THE

INSULATIONS

OF MOTOR,

AND MAINS

AND MOTOR

CABLE.

See Manual.

7

2.

1.

3.

2.1.

3.

1.

2.

INPUT

Motorcable

300 mmfree space

ACS 600 Installation GuideACF 601-0016-3/5, ACx 601-0020-3 ... -0070-3,

-0025-5 ... -0100-5 and -0025-6 ... -0070-6

10

7

7

15

8/12/2019 Ins_r4r6

2/2

1. Connect the motor cable.

2. Connect the mains cable.

Ensure proper earthings.

For minimal radio frequency

interference (RFI) at the motor

end:

1. Twisted screen:

Diameter () >1/5 Length (L),

or

2. Screen 360 earthing at cable

lead-through.

L

8

9

Control cable installation:

1. Make hole to a control cable

grommet and lead the cable into

the unit.

2.Connect the earthing wires and

the cable shield to the earthing

terminal next to the NIOC board.

3. Connect the control cables to

the input/output terminals.

1. Replace the cover.

2. Replace the telephone

connector of the Control Panel.

3. Replace the Control Panel.

10

1.

2.

2.3.

1.

Earthing Wires

and the cable shield 3.

300 mmfree space

ABB IndustryOy Drives P.O. Box 184 FIN-00381 Helsinki tel: +358-10 22 2000 fax: +358-10 22 22681

Code:

3AFY5

8972665R0225REV

A

Effective:3.3.1

998/EN

Standard

Input/Output

Connections: See

theStart-up

Guide or Manual.