Upload
sureshkvl
View
220
Download
0
Embed Size (px)
Citation preview
8/17/2019 Inbound Loadbalance DNS
1/10
DNS Inbound Load Balance (1/10)
Examples:1.An FTP server (IP_192.168.2.2) and an HTTP server (IP_192.168.2.3) are connected to the Internet via WAN1
(IP_200.200.200.1) and WAN2 (IP_100.100.100.1) on the BiGuard 30.
2.Register www.mydomain.com to your domain service provider and set 200.200.200.1 as primary DNS server I
and set 100.100.100.1 as secondary DNS server IP.
3.BiGuard 30 can direct incoming DNS queries to either WAN port based on the amount of load each WAN port
currently experiencing. If WAN1 is experiencing a heavy load, the BiGuard 30 responds to incoming DNS query
with WAN2 IP address.
8/17/2019 Inbound Loadbalance DNS
2/10
Step 1: Go to Configuration > WAN > ISP Settings. Select WAN1 and WAN2 and click Edit.
Edit
WAN1/WAN2
ISP settings
DNS Inbound Load Balance (2/10)
8/17/2019 Inbound Loadbalance DNS
3/10
Step 2: Configure WAN1 according to the information given by your ISP.
Specify WAN1
ISP settings
DNS Inbound Load Balance (3/10)
8/17/2019 Inbound Loadbalance DNS
4/10
Step 3: Configure WAN2 according to the information given by your ISP.
Specify WAN2
ISP settings
DNS Inbound Load Balance (4/10)
8/17/2019 Inbound Loadbalance DNS
5/10
DNS Inbound Load Balance (5/10)
Step 4: Go to Configuration > Dual WAN > General Settings. Select the Load Balance radio button
(a) Select the “Load Balance” radio button.
(b) Choose “Enable” for Service Detection if needed
(c) Click Apply
(a) Click Load
Balance Button
(b)ChooseService Detection
Button if needed
(c)Click Apply
8/17/2019 Inbound Loadbalance DNS
6/10
Step 5: Go to Configuration > Dual WAN > Inbound Load Balance. Click Enable button. Click Edit to input the
DNS Server/Host URL Mappings settings.
(a)Click Enable Button
(b)Click Edit to edit DNS server
1 and Host URL mappings
(c)Click Edit to edit DNS server2 and Host URL mappings if
needed.
DNS Inbound Load Balance (6/10)
8/17/2019 Inbound Loadbalance DNS
7/10
Input the DNS server
settings
Step 6: Go to Configuration > Dual WAN > Inbound Load Balance > DNS Server 1 > Server Settings Edit .Input the DNS server settings.
DNS Inbound Load Balance (7/10)
8/17/2019 Inbound Loadbalance DNS
8/10
Step 7: Go to Configuration > Dual WAN > Inbound Load Balance > DNS Server 1 > Host URL Mapping Edit> Create. Input the Host URL mappings. (e.g., ftp server)
Input the Host URL
mappings (ftp)
DNS Inbound Load Balance (8/10)
8/17/2019 Inbound Loadbalance DNS
9/10
Step 8: Go to Configuration > Dual WAN > Inbound Load Balance > DNS Server 1 > Host URL Mapping Edit> Create. Input the Host URL mappings. (e.g., www server)
Input the Host URL
mappings (www)
DNS Inbound Load Balance (9/10)
8/17/2019 Inbound Loadbalance DNS
10/10
Step 9: Click SAVE CONFIG to save all changes to flash memory.
Press SAVE CONFIG
DNS Inbound Load Balance (10/10)