Embed Size (px)
Citation preview
Bussmann series technical training seminars span 1.5 days and are hosted in our dedicated, hands-on Vince Saporita Technical Center at our Ellisville (St. Louis suburb), Missouri, location. Each seminar includes a live demonstration of misapplied devices in our Paul P. Gubany Center for High Power Technology.
After completion of each training seminar, participants will receive a certificate of completion for Professional Development Hours (PDHs).
2019 training seminars
April 23-24
June 25-26
BUSSMANN SERIES PRODUCT ANDTECHNICAL TRAINING
IMPROVE YOUR KNOWLEDGE OF ELECTRICAL SAFETY AND CIRCUIT PROTECTION
Overcurrent protection fundamentals and selective coordination for consulting and design engineersOur seminar for consulting engineers, contractors and inspectors is focused on proven overcurrent protection principles, based on the 2017 NEC®.
2019 training seminars
April 2-3
June 11-12
Overcurrent protection fundamentals and SCCR for OEMsOur seminar for OEMs is focused on industrial control panels, industrial machinery, motor circuits, UL® standards and the 2017 NEC.
2019 training seminars
March 26-27
May 7-8
September 10-11
Bussmann series product training for distributorsOur seminar for Bussmann series product distributors is focused on a blend of technical, commercial and hands-on product training.
Registration is by invitation only. Please contact your local Bussmann series product sales person or rep. Visit Eaton.com/bussmannseries for more information.
EatonBussmann Division114 Old State RoadEllisville, MO 63021United StatesEaton.com/bussmannseries
© 2019 EatonAll Rights ReservedPublication No. 10479February 2019
Eaton and Bussmann are valuable trademarks of Eaton in the US and other coun-tries. You are not permitted to use the Eaton trademarks without prior written consent of Eaton. NEC is a registered trademark of the National Fire Protection Association, Inc.UL is a registered trademark of the Underwriters Laboratories, Inc.
