IKS UPGRADE GUIDE FOR AZ S&S HD1. Upgrade your STBCopy the *.abs file to your USB stick and insert to the USB slot of your receiver, select Menu->Upgrade->Upgrade By USB->Upgrade Mode: firmware->Upgrade file:*.abs->start until the STB restart

2. Input your pin codePress 2580 on remote control->select IKS on and press"OK"->input your pin code, e.g. 10-123456-123456-12345,it means your pin code is 010-123456-123456-12345. The pin code must be 20 digits:01012345612345612345. Otherwise it will not work for IKS. (Press red button"DEL" to delete the old digits). After inputting the pin code, press "OK".

3. Active your pin codePress "Apply" and then exit and wait for about 50 seconds and you can see the start date and end date is changed.

4. Enjoy your favorite channelsPress ok key and then you can see the encrypted channels come back with green color mark.

If you can't watch by IKS, please reboot your STB to check the pin code and the end date whether they are correct or not and the internet is connected well or not.