IDRO GAS ENGINEERING S.A.S.

www.idrogasengineering.it

ADVANCED FITTING SYSTEMFOR WATER AND GAS PIPELINES

RAPIDOPipe saddles available from DN 25 to DN 1500, for castiron/ductile iron, A/C, steel, fiber-glass,PVC/PE and concrete pipes.Threaded or flanged outlet up to 6”.

EUROPAService connection valves, designed for the use also with saddles type

“RAPIDO”, with internal sealing plug with elastomeric rubber, soft sealing andstem made of stainless steel.

Sizes from ¾” to 2”.

TREPIWide tolerance three-part clampsfor repairing and tapping underpressure. Threaded or flangedoutlet up to 8”, available in sizesfrom DN 40 to DN 800 for castiron/ductile iron, A/C, steel,fiber-glass and concrete pipes.

DUEPIWide tolerance two-part clamps for repairing and tapping

under pressure. Threaded outlet ½”, available in sizes fromDN 15 to DN 200.

INOXGISWrap-around clamps for repairing under pressure, produced

in a variety of lenghts for sizes from DN 15 to DN 2000.Suitable for cast iron/ductile iron, A/C, steel,

fiber-glass, PVC/PE and concrete pipes.

ETERNOEntirely stainless steel wrap-around clamps for repairing ortapping under pressure, produced in a variety of lenghts for sizesfrom DN 15 to DN 2000, with threaded or flanged branch up to8”. Suitable for cast iron/ductile iron, A/C, steel,fiber-glass, PVC/PE and concrete pipes.

STOPAdjustable bell joint repair clamps for the leak repair of socketsand spigot joints on cast iron/ductile iron pipes.They can also

be used for the repairing of leakages on joints of pipes ofother material (A/C, fiber glass, steel, plastic).

Available in sizes from DN 50 to DN 1200.

UNIVERSALEUltra-wide, wide and medium tolerancecouplings/adaptors/end-caps (compression type). Available insizes from DN 20 to DN 800.

The drawings, photographs, sizes and technical datas are not binding but can be varied for constructive ormarket reasons. Even partial reproduction of texts,drawings or photographs is forbidden by law.

DEALER

UNIVERSALE SP

FORATUBI

CHIUSINI

Idro Gas Engineering S.A.S.Via Roma 10113010 Motta de’ Conti (Vc)Italy

VAT: IT 01466450069

tel.: ++390161780400 - 780444fax: ++390161780909 - 780411

e-mail: info@idrogasengineering.itwww.idrogasengineering.it

Tailor-made fittings in steel(couplings/adaptors/stepped couplings/end-caps),available in sizes from DN 100 to DN 2000.

Pipe drilling machine to use in connection with our “RAPIDO”,“TREPI”, “DUEPI” and “ETERNO” products on every kind of

pipe. Drill sizes from ½” to 6”.

Various types of surface boxes used for valves,hydrants, air releases, etc. All types are with adjustableheight.