Upload
kjaerulff-1-digital-as
View
274
Download
10
Embed Size (px)
DESCRIPTION
The Icotera IGW1000v2 is a fully featured Layer 2 gateway, with an advanced feature set. IGW1000v2 is targeted towards open access networks, and in general, operators with a layer 2 demarcation point.
Citation preview
www.icotera.com Icotera A/S reserves the right to change specifications without further notice.
IGW1000v2 Residential Switch
Single mode fiber (ITU-T G.652)SC/PC connectorTx: 1310nm, RX: 1480-1600nm100BaseBX10/20 and 1000BaseBX10/20 compatibleOperating distance: 20kmTransmit power: -7 - -2dBmReceive sensitivity: -3 - -23dBmClass 1 laser productJumbo packetsOptical signal monitoring (optional)Link propagation
LAN INTERFACE
LAYER 2 FEATURES
IP source guardARP inspectionOSI Layer 3 and 4 filtering
4 or 8 x 10/100/1000 Base-T(x)RJ45 connectorAuto-negotiation for speed and duplexAuto MDI/MDXJumbo packetsLink propagation
Jumbo packet forwardingOSI Layer 2 filtering4k VLANVLAN filteringVLAN remappingVLAN terminationMAC limiting (1-254, or disabled)IGMP v1/v2/v3 snoopingMLD v1/v2 snoopingQinQPort mirroringLoop detectionBroadcast suppressionIEEE802.3az
WAN INTERFACE
LAYER 3 FEATURESIGW1000v2 Residential Switch
The Icotera IGW1000v2 is a fully featured Layer 2
gateway, with an advanced feature set. IGW1000v2 is
targeted towards open access networks, and in general,
operators with a layer 2 demarcation point.
The IGW1000v2 features all the must-haves:
• Gigabit forwarding
• Optical auto detection (100BaseBX10/20,
1000BaseBX10/20)
• Advanced CATV (optional)
• IEEE802.3az EOAM
But besides that, also more advanced features like:
• Ethernet and IP filters (layer 2-4)
• MAC limiting
• IP source guard
• Jumbo packets
• Optical signal monitoring (CATV and DATA)
• SNMP v1/v2 interface
• VLAN forwarding/altering and filtering
• Link propagation
• Green (power management)
All is done in hardware, resulting in blazing wirespeed
gigabit transfer rates. Yet, the IGW1000v2 can boot in
less than 2 seconds, giving the instant-on feeling for the
end user.
www.icotera.com Icotera A/S reserves the right to change specifications without further notice.
IGW1000v2 Residential Switch
MANAGEMENT & MONITORING
STATUS LEDs
QoS
FIBER TERMINATION UNIT (FTU)
CATV
GENERAL SPECIFICATIONS
IPv4/IPv6 management interfaceSeperate VLAN (optional)Access filtering based on IP source networkZero-touch provisioningAutomatic firmware update64bit port counters Unicast Packet size (64, 128, 256, 512, 1024, 1518, 9k) Multicast Broadcast FCS error Allign error Undersized Fragmented
Too long Good byte Bad byte Overflow Filtered CollisionsSNMP v1/v2 IF-MIB2 Icotera private MIB Community protected Traps802.3ah OAM Link performance monitoring Fault detection Loopback testing
Configurable by operatorAuto off, after timeout periode3 front LED’s Power/Status WAN status (link/traffic)
CATV statusLink/traffic/duplex LEDs per LAN interface
4 x Queues per interfaceIngress/Egress rate limiting per port queue access list Rate limiting in 32Kbps stepsDSCP mapping/remapping
ToS mapping/remapping802.1p mapping/remappingMechanisms Weighted round robin Strict Hybrid Queue
The IGW FTU is an optional part numberSlide-on mechanism for easy installationFTU support for Gas block unit (sold separately) WDM filter (sold separately)Optional blind cover for FTU
OPTICAL PARAMETERS:Saturation power: 3 dBmInput level range: -10 to 0 dBmInput wave length: 1310/1550 nmOptimal AGC range -6 to 0 dBmEquivalent input noise (amplifier + diode): 8 pA/√HzResponsivity λ=1310nm: 0,8 A/WResponsivity λ=1550nm: 0,9 A/WOptical connector: SC/APCStandard Single Mode fiber (ITU-T G.652)Software monitoring of RX level in 0.1dB steps.
RF PARAMETERS:Frequency range: 45 to 900 MHzOutput level at -3dBm (0 dB slope, 3,5% OMI w/2 filters): 75dBuVOutput level at -3dBm (4 dB slope, 3,5% OMI): 78dBuVLinearity: ±1 dBCNR (CENELEC 42 channels): >= 51 dBCSO (CENELEC 42 channels): <= 65 dBcCTB (CENELEC 42 channels): <= 65 dBcRF filters (optional): up to 2Filter attenuation in block band: > 50 dBFilter attenuation in pass band: < 3 dBFilter and output power level controllable by softwareRF connector 75 Ohm “F”
DC5V input (±10%)Power consumption maximum: 2wattsOperating temperature: 0 - 45°cStorage temperature: -20 - 85°c
Humidity: 5% - 95% (non-condensing)Weight: 800gSize: 190 x 110 x 48 mm (W x H x D)
Icotera partner: