INTRODUCTION TO ROBOTICSCPSC - 460

Lecture 2A – DH Notation

TEXTBOOK

Robotics, Vision and Control - Fundamental Algorithms in MATLAB, Peter Corke, Springer, 2011

Author: Peter Corke

Publisher: Springer

ISBN: 978-3-642-20144-8

KINEMATICS Kinematics is the branch of mechanics that studies

the motion of a body or a system of bodies without considering its mass or the forces acting on it.

Forward (direct) Kinematics Given: The values of the joint variables. Required: The position and the orientation of the

end effector.

Inverse Kinematics Given : The position and the orientation of the end

effector. Required : The values of the joint variables.

DESCRIBING A SERIAL MANIPULATOR

A serial manipulator comprises a set of bodies, called links, in a chain and connected by joints.

Each joint has one degree of freedom, either translational (prismatic joint) or rotational (a revolute joint).

Motion of the joint changes the relative angle or position of its neighboring links.

The joint structure of a robot can be described by a string such as “RRRRRR” for the Puma “RRPRRR” for the Stanford arm

KINEMATICS

For a manipulator with N joints numbered from 1 to N, there are N +1 links, numbered from 0 to N

Any given joint j connects links j-1 and j

Link 0 is the base of the manipulator and link N carries the end-effector

WHY DH NOTATION

A systematic way of describing the geometry of a serial chain of links and joints was proposed by Denavit and Hartenberg in 1955 and is known today as Denavit-Hartenberg notation or simply D-H notation.

A very simple way of modeling robot links and joints that can be used for any kind of robot configuration.

This technique has became the standard way of representing robots and modeling their motions.

DH TECHNIQUES

7

DH TECHNIQUES

A link j can be specified by two parameters, its length aj and its twist αj

Joints are also described by two parameters. The link offset dj is the distance from one link coordinate frame to the next along the axis of the joint. The joint angle θj is the rotation of one link with respect to the next about the joint axis.

DH TECHNIQUES

9

DH TECHNIQUES

10

DH TECHNIQUES

•Link twist αi :the angle from the Zi-1 axis to the Zi axis about the Xi axis. The positive sense for α is determined from zi-1 and zi by the right-hand rule.

•Joint angle θi the angle between the Xi-1 and Xi axes about the Zi-1 axis.

DH TECHNIQUES

The four parameters for each linkai: link length

αi: Link twist

di : Link offset

θi : joint angle

With the ith joint, a joint variable is qi

associated where

12

DH TECHNIQUES

All joints are represented by the z-axis.

If the joint is revolute, the z-axis is in the direction of the axis of rotation as followed by the right hand rule.

If the joint is prismatic, the z-axis for the joint is along the direction of the liner movement.

DH TABLE - EXAMPLE I THE TWO LINK PLANAR ARM

14

• Base frame O0

•All Z ‘s are normal to the page

DH TABLE - EXAMPLE 2

15