Upload
marion-lucas
View
219
Download
1
Embed Size (px)
Citation preview
2
HYDROMETERS Combination
- Master valve- Water meter- Flow sensor
Available sizes 1½” to 8”:
- 1½” and 2” are threaded- 3” to 8” are flanged
Accommodate flow ranges from 1.8 gpm to 1500 GPM
3” Hydrometer
1 1/2” Hydrometer
4
APPLICATIONSMASTER VALVE, FLOW SENSOR COMBINATION Ideal for places where space is limited Requires no straight pipe upstream or downstream for
accurate measuring-- ± 2% in accuracy Fully compatible with most central control systems Available configurations:
- Manual Electric Normally Closed (-MEL)- Manual Electric Normally Open (-MEL-NO)- Pressure Reducing Electric Normally Closed (-PRMEL)- Pressure Reducing Electric Normally Open (-PRMEL-NO)
6
HYDRAULIC VALVE PERFORMANCE Precision hydraulic valve and water
meter in a single unit Perfect as a master valve and flow
sensor Saves space and installation costs Rugged heavy duty construction
3” Hydrometer
7
HYDROMETER FEATURES Double chamber valve for positive opening and
closing – no springs required 6” Hydrometer is single chamber Adding pilot valves and solenoids enables remote
and automatic operation Hermetically sealed register – just one part
touches water Optional control functions
- Manual Electric- Pressure reducing manual electric- Other configurations upon request
8
HYDROMETER FEATURES
Upper and lower valve
chamber
Straightening vanesImpeller
Hermetically sealed register in a dry
compartment
Straightening vanes allow compact installation - no upstream or downstream straight pipe requirements
Low head loss Ideal for high pressure
applications
9
HYDROMETER SPECIFICATIONS
Maximum Working Pressure 235 psi
Minimum Working Pressure 14 psi
Maximum Liquid Temperature 140° F
Body Material Cast Iron with Epoxy Coating
Connections Flanged, Threaded
Diaphragm Reinforced Natural Rubber
SPECIFICATIONS
10
INSTALLATION REQUIREMENTS Must install upright Pipeline should be thoroughly
flushed before installation No straight pipe installation
requirements Install proper size and type of air
vents to eliminate air
3” HydrometerStraight Pipe Install:
Upstream: 0 x D Downstream: 0 x D
11
METER REGISTER WITH PULSE OUTPUT Pulse output is standard Allows for communicating
with most central controllers, data loggers, and monitoring equipment
12
PULSE OUTPUT MODELS AVAILABLE Low frequency “dry contact” using a
reed switch - 1 or 10 gallons per pulse
Photo diode—higher frequency than dry contact by a factor of 10 - 0.1 to 1 gallon pulse
High frequency photo diode provides from 10 to 200 pulses per second (depending on the flow rate)
Register with Reed Switch
Register with Photo Diode Output
13
RECOMMENDED REGISTER OUTPUT
Recommended Register Type.
MANUFACTURERCONTROLLER
MODELRECOMMENDEDREGISTER TYPE
Baseline Basestation PDHHunter ACC 2-Wire PDH
Rain Bird MDC & Maxi RSSignature All Models RS
Sentinel PDHTDC 2-Wire PDH
RS (1” to 4”)PD (6” and 8”)
Toro
Toro Rainmaster All Models
14
HYDROMETER PERFORMANCE DATA
Lowest Flow Lowest Flow Nominal Flow Maximum Flow Within ± 5% Accuracy Within ± 2% Accuracy Within ± 2% Accuracy Within ± 2% Accuracy
1 1/2" 1.8 GPM 4.4 GPM 44 GPM 55 GPM
2" 5.3 GPM 20 GPM 66 GPM 95 GPM
3" 14 GPM 53 GPM 176 GPM 220 GPM
4" 21 GPM 79 GPM 264 GPM 380 GPM
6" 53 GPM 198 GPM 660 GPM 860 GPM
SizeLowest Flow Lowest Flow Nominal Flow Maximum Flow
Within ± 5% Accuracy Within ± 2% Accuracy Within ± 2% Accuracy Within ± 2% Accuracy
1 1/2" 1.8 GPM 4.4 GPM 44 GPM 55 GPM
2" 5.3 GPM 20 GPM 66 GPM 95 GPM
3" 14 GPM 53 GPM 176 GPM 220 GPM
4" 21 GPM 79 GPM 264 GPM 380 GPM
6" 53 GPM 198 GPM 660 GPM 860 GPM
Size
1½” Globe Hydrometer 3” Globe Hydrometer
Cv Flow Rate @ 1.0 psi
of Headloss1 1/2" 23 GPM
2" 35 GPM
3" 92 GPM
4" 139 GPM
6" 347 GPM
8" 624 GPM
Size
Cv Flow Rate @ 1.0 psi
of Headloss1 1/2" 23 GPM
2" 35 GPM
3" 92 GPM
4" 139 GPM
6" 347 GPM
8" 624 GPM
Size
15
WHY USE A HYDROMETERSAVES SPACE Combination master valve, water meter and flow sensor all in
one unit Does not require any upstream or downstream straight pipe for
proper function.
ACCURACY ACROSS A WIDE FLOW RANGE Accuracy is ±2% across the entire flow range—offset is = 0
WATER METER CANNOT LOOSE DATA Standard with odometer register