Full Control over Indoor Units Operation •

On/Off control, Cool, Heat, Fan, Dry mode selection, Set Temperature •

Control, Fan Speed Control, Swing Control (for wall mounted and cassette

indoor units), Filter Reset Sign, Group Operations (All On, All Off)

Outdoor and Indoor Units Monitoring •

Failure Alarms, Set point temperature, Operation status (on/off) Operation •

mode (cool/heat/fan/dry), Fan speed (high/low), Filter sign, Swing

Compatible with Daikin/Sanyo/Toshiba/ Mitsubishi Electronic/Hitatchi air •

conditioning systems

The Vantage HVAC InterfacePoint makes it easy to

integrate HVAC systems in the Vantage InFusion

System.

5 different hardware devices are available: HVAC-ID (for

Daikin), HVAC-IS (for Sanyo), HVAC-IT (for Toshiba),

HVAC-IM (for Mitsubishi Electric), HVAC-IH (for Hitachi)

but only 1 driver in the Vantage software. The HVAC

Interface System gains full control on indoor units and

provides access to the system parameters.

It allows homeowners full control with the Vantage

System keypads, touchscreens, motion sensors, timers

etc. and gives feedback from the actual temperature

and setpoints on the TPT touchscreens.*

It simply connects straight to the air conditioning system

two wire communication lines and a Vantage RS-232

control port.

*Temperature feedback not for the Hitachi Interfaces.

Easy set-up in InFusion Design Center

Product Highlights

HVAC

HVAC InTERFACEPoInT

HVAC InterfacePoint

Specifi cations

Thermostat Dimensions 62mm x 112mm x 30mm

2.45”x4.4”x1.18”

Model HVAC-InterfacePoint: HVAC-ID (for Daikin), HVAC-IS (for Sanyo)

HVAC-IT (for Toshiba), HVAC-IM (for Mitsubishi Electric), HVAC-IH (for Hitachi)

Weight 125g (4.4oz)

Serial Connection DB9 Female

HVAC Connection Line Two screw terminals

Power Input 20-30 Vac (24VAC nominal), 60/50Hz

Power Supply 9VDC 100mA included

Typical Control Accuracy ± 1°F at 68°F / ± 0.5°C at 20°C

LCD Display Information On/Off control

Cool, Heat, Fan, Dry mode selection

Set Temperature Control, Fan Speed Control, Swing Control

Filter Reset Sign, Group Operations

InFusion with feedback on the Vantage touchscreen

QLink control codes

General Specifi cations

System Compatibility

Dimensions, HWD

INSIDE VIEWFRONT VIEW

To Vantage Serial Port

HVAC-IDVANTAGE INTERFACEPOINT FOR DAIKIN

62mm (2.45”)

112mm (4.4”)

To AC SystemTo Power Supply

To Vantage Serial Port

To Power Supply

To AC System

LCDCPU

Vantage emea nv/saBinnendijk 40 | 9130 Beveren | BelgiumT +32 (0) 3 773 31 06 | F +32 (0) 3 773 31 05 www.vantage-emea.com