LT - HT PANELSEngineered for Performance, Tested for Reliability

A pioneer in the world of electrical solutions since 1998. Gaurav Transformers & Electricals is a legend of the future. Born out of quality and commitment to deliver. GTE has established itslef as the foremost providers of exhaustive electrical products. GTE is set to redefine standards.

State-of-the-art infrastructure combined with the best management resources enable us with a high degree of flexibility and precicsion, allowing us to deliver you nothing short of the best.

We adapt ourselves to the times and upgrade ourselves with international technological updations. Our in-depth grasp o f the profession, works towards bringing you the most internationally appropriate and Cutting-edge solutions across INDIA in the most hassle-free, practical and scientific manner.

OUR ESSENCE

OUR EXTENTGaurav Transformers & Electricals is a clan of over 75 employees including more than 40 ground staff and 25 teams dedicated to making an epochal difference in the industry. We’ve been witnessing a consistent growth over our performance for the past few years. Our quality and expertise have left their imprints in the industry.

Ÿ LT Panels:LT Panel is an electrical distribution board that receives power from generator or transformer and distributes the same to various electronic devices and distribution board. Our LT panels are designed to work with low electricity consumption that makes them cost effective manufacture Automatic Power factor Control(APFC) panels, Machine Control panels, Power Control Center.

Ÿ HT Panels:HT means high tension or high voltage, where in a small current is used with a very high voltage(for creating plasma).HT Panel is like LT Panel except that it is used for high tension cables.

LT-PANELSŸ Rated current upto 6300A.Ÿ Fault level upto 100KA for 1 sec.Ÿ Construction of Panel : 2A/2B/3A/3B/4A/4B.Ÿ Seismic zone IV & V certified.Ÿ Degree of Protection: IP 52/IP 42/IP 54/IP 65.Ÿ Bus bar: Aluminum or Copper.Ÿ Interleaved design of Main bus bar for ratings above 3200A.Ÿ Panels are functionality color coded for easy identification of

feeders.Ÿ Transformer I/C Feeder - Blue. Ÿ Diesel Generator Incomer Feeder - Orange. Ÿ Bus Coupler Feeder - Off White.Ÿ O/G Feeders - Siemens Grey RAL-7032.

¯ In this system there are many kinds of panels :- 1. Power control centers (PCC) up to 10,000 A.2. Motor control centers (MCC), Distribution panels.3. Automatic Power Factor Controller (APFC) and Capacitor controlpanels.4. Auto Mains Failure (AMF) panels.5. Bus ducts up to 15,000A.6. Bigger starters for Slip ring and Auto transformer starters, Soft start Starters. PLC , DCS, based systems and process control panels. 7. D.G.Set Canopy, Compressor control panels for Winery and chilling plants. 8. Fire protection panels, Control desks, and Custom built panels.***We manufacture transformers on any specifications asked by the customers.

POWER CONTROL CENTERS(PCC)

Ÿ The Power Control Centers comes in LT-HT Panels. The Power Control Center (PCC) has a compartmentalized panel with a current carrying capacity up to 6300Amp.

Ÿ PCC is a common control panel with different vertical sections from where the different electric parameters are monitored and controlled.

Ÿ This range of PCC’s is very effective in handling very high current at low voltage .

Ÿ Our Power control Centers (PCC) are used for diverse industrial applications.

Ÿ We manufacture Power Control Centers Upto 6300A rating, suitable for operational Voltage of 4.15V in a 3-Phase 4-wire system.

Ÿ Our PCC's are made to IS 8623 specification & has a Short circuit withstanding capacity of 65 KA for 1 Sec.

Ÿ Our PCCs can be supplied with in-built load scheduling systems and alarms which help to trip the identified non-critical loads when the source (EB/DG) is overloaded.

Ÿ We can provide the IP: 54 & IP: 55 degree of protection with single front / Double Front design.

Ÿ These panels are made of quality raw material and are ex-tremely sturdy in construction.

AUTOMATIC POWER FACTOR CONTROL PANEL (APFC)

Ÿ We offer APFC panels with Capacitor Banks with ample space provided for the Capacitors within the panels for efficient heat dissipation.

Ÿ We also ensure that proper care is taken against the Re-switching ON of the Capacitor Bank before it is fully dis-charged.

Ÿ We also manufacture a Real Time Automatic Power Fac-tor Correction Panel, which is also known as a Thyristorised APFC Panel. In these panels, Thyristors are used instead of Contractors for switching the capacitors.

Ÿ The capacitors are switched at Zero point on the AC wave form on account of which no harmon-ics, in-rush current or surges are generated at the time of switching of capacitor in the network.

Ÿ This method of switching also increases the life of capac-itors and efficiency of the electrical instal-lation.

Ÿ Our Thyristorised APFC panels are programmed to activate required no. of capacitor banks automatically irrespective of the source (EB/DG) to ensure harmonics re-duction.”

MOTOR CONTROL CENTERS(MCC)

Ÿ In many commercial and industrial applications, quite a few electric motors are required, and it is often desirable to control some or all of the motors from a central location.

Ÿ The apparatus designed for this function is the motor control center (MCC).

Ÿ Motor control centers are simply physical groupings of combination starters in one assembly.

Ÿ A combination starter is a single enclosure containing the motor starter, fuses or circuit breaker, and a device for disconnecting power.

Ÿ Other devices associated with the motor, such as pushbuttons and indicator lights may also be included.

Ÿ We manufacture MCC of Single Front & Double Front Design which are made to IS 8623 & Short Circuit with-standing capacity of 65 KA for 1 Sec.

Ÿ Our MCCs are compatible with automation systems like BMS / SCADA and energy manage-ment systems.

Ÿ We can provide the IP: 54 & IP: 55 degree of pro-tection.Ÿ Switchboards offered are in Fixed and Draw-out type

configuration. Starters include :-

1 Automatic Star / Delta Drives .

2 Direct on line.

3 Variable Frequency Drives.

4 Soft Starters.

HT- PANNELS

Ÿ HT Panel is like LT Panel except that it is used for high tension cables.

Ÿ HT panels are compact outdoor type systems, which are broadly used in substations.

Ÿ Our product range is prepared from Circuit Breakers or switch fuse on HT side, which protects the equipment from sudden voltage fluctuations.

Ÿ HT panels are precisely designed following strict industry parameters and are appreciated for features like superior quality and cost effectiveness.

Ÿ HT Panels are also available from original equipment manufacturers (OEM) to incorporate installations or for use in repair, retrofit and upgrade projects.

CORPORATE OFFICEB-94 Kamla Nagar, AGRA-282005

Ph:09319065826,09837082789,08279938908WORKS

G-12, New RIICO Industrial Area,Ondela Road, DHOLPUR-328001,

RAJASTHAN.Ph: 08279939388E-mail: gte.sale@gmail.com,gtransformers@gmail.com

WEB: www.solartransformer.in

Follow us on: