Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
How to install SKU273392
1. Place the panel on the back of the tear film, flat attached to the front of the housing, with the indicator at the black circle as a reference alignment:
2. Install the test seat, banana sockets and other accessories:
3. Place the pin bent into the right position, the socket of pin1 and pin 2 together as a test terminal 1. Pin 4 and pin 5 together as a test terminal 3. In the middle of Pin 3 as the test side 2:
4. The pins are soldered to be connected together, and with copper leads backup:
5. The tester welding is completed, battery snap and green test seat is not installed:
6. The circuit board tester with a nylon column heightening, self-tapping screws:
7. The three test leads welded end:
8. Place the battery from the battery compartment through the buckle, the welded plate, square pad is negative, you can use the hot melt fixed:
9. Install knobs, install the battery, fasten the battery cover, complete: