Upload
others
View
4
Download
0
Embed Size (px)
Citation preview
HCR 900-ESIIGeneral View
Perfect combination of performance and economyThis equipment is the perfect combination of performance and economy. The drifter HD709 is designed to reduce noise and vibration without reducing performance. It has the hydraulic controls that automatically adjust the impact to each type of rock and it has a low voltage chassis that improves stability, granting greater confidence to the operator during transfers.
FEATURES
It uncludes Drifter HD709, designed to reduce noise and vibration without sacrificing performance.
Versatile design which allows to drill horizontally and vertically.
The extendable arm increases the flexibility in the drilling pattern.
Stable and protected chassis, with low center of gravity which increases stability at the moment of transporting and at the moment of drilling in difficult terrain.
Sliding suction cap can be raised to allow a quick visual check of the operation.
It has a high power compressor that provides faster drilling, decreasing bit wear.
Engine, compressor and oil temperature gauges are easy to see, which allows to the operator to control the functions of the equipment at any moment.
Perforation between 18 and 20 meters deep, depending on the model.
Potent engine Caterpillar C7 of low consumption of fuel and low polluting emissions.
Technical Specifications
Operating Weight 10.270 kg Model Airman PDS265-S35B
Total Length 9.750 mm Type Tornillo de 01 Etapa
Operating Width 3.220 mm Air Volume 102 l/seg
Transport Width 2.570 mm Air Pressure 10.3 bar
Total Height 2.730 mm
Elevation Angle (up-down) 45º - 15º
Model HD709 Turn Angle (right-left) 37º - 43º
Weight 185 kg Arm Extension Yes
Power 14 kW
Impact Frequency 2.250 - 2.500 bpm Model GH831
Number of Rotations 0 - 250 rpm Length 7.534 mm
Extension 1.500 mm
Caterpillar Length 3.060 mm Twist Angle (right-left) 40º - 40º
Support Surface 2.425 mm Tilt Angle 180º
Shoe Width 300 mm Pushing Force 28.5 kN
Ground Clearance 550 mm
Swing Angle ± 10º Suction Capacity 20 m³/min
Speed of Displacement 0 - 3.5 km/h Air Filter 4 pcs
Maximum Slope 30º
Length of Bar 3.660 mm
Brand / Model Caterpillar / C7 Tier III Number of Bars NA
Output Power 168 kW / 2.200 rpm Size Bars H32-R38-R45-(H38)
Fuel Capacity 330 lts Initial Max.Length Bar 4000/6000 (Optional) mm
Hydraulic Capacity 170 lts Drill Diameter 64 - 102 mm
ENGINE
EXCHANGER BARS/DRILL BITS
ADVANCE BEAM
DUST COLLECTOR
GENERAL DATA COMPRESSOR
ARM
DRIFTER
DISPLACEMENT UNIT