Upload
lizbeth-warner
View
214
Download
0
Tags:
Embed Size (px)
Citation preview
Harding High School
Technology Lab Safety Power Machine Review
Mr. Pottkotter & Mr. Robinson
Table Saw
ON/ OFF
BUTTONS
MITER GUIDE GROOVE
BLADE
GUARD FENCE
BLADE HIEGHT ADJUSTMENT WHEEL
BLADE ANGLE ADJUSTMENT WHEEL
TABLE
Table Saw
• Always use the _________ when ripping a piece of stock.– Fence
• If the stock _________, hold it down tight and turn the saw off.– Pinches
Table Saw
• Always ________ until the blade stops moving before removing any stock from any machine.– Wait
• Use the ________ when crosscutting a piece of stock.– Miter Guide
• Always use the _______ when ripping a piece of stock.– Fence
Band Saw
On/ Off ButtonBlade
Table
Blade Guard/Guide
Scroll Saw
On/ Off
Table
Hold Down Clamp
Ban Saw
• If the _______________, turn off the machine and tell the instructor.– Blade Breaks
• Use ___________ when making sharp curve cuts.– Relief Cuts
Ban Saw
• Always keep a _______ safety margin between your fingers and the blade.– 3”
• Never adjust the _______ when the machine is running.– Guard
SurfacePlaner
Thickness AdjustmentWheel/ Guide
Thickness Gauge
On/ Off Buttons
Cutter Head (Inside)
Feed Rollers
Infeed Table
Surface Planer
• This machine cuts the _______ side of the stock.– Top
• Let the machine reach ____________ before putting the stock in.– Full Speed
• Keep _______ back so they are not pinched between the stock and the table.– Fingers
JointerOutfeed Table Guard
Infeed Table
Fence
Infeed TableAdjustmentWheel
Jointer
• Never _____ when the machine is running.– Leave
• Never stand directly ________ the stock when using this machine.– Behind
• You use this machine to smooth and straighten ______ edge of a piece of stock.– One
Jointer
• Use a _______ when working with a small piece of stock.– Push Stick
• Never run the stock ______ the grain on this machine.– Against or Across
• Always keep the stock ______ against the fence.– Tight
Radial Arm Saw
Guard
Table
On/ Off
Buttons
Yoke
Fence
Radial Arm Saw
• Always return the saw to the ______ of the table after each cut.– Rear
• Always hold the stock tight against the _____ when using this machine.– Fence
• Never _____ the saw when the blade is moving.– Leave
Radial Arm Saw
• Hold onto the saw when ______ to prevent the blade from moving forward.– Starting
• The blade should extend ______ into the table.– 1/8”
Compound Miter Saw
Turntable
Handle
Guard
Fence
Table Top
Side Handle
Compound Miter Saw
• Always keep all ______________ in place.
• You should keep your hands and fingers at least how far from the saws path?
Guard
4 inches
Compound Miter Saw
• Let the saw reach full _______________ before you begin cutting your piece.
• You always want to secure your work piece to the fence or table using _________.
Speed
Clamps
Drill Press
On/ Off Buttons
Spindle Adjustment
Lever
Table
Column
Chuck
Table Lock
Drill Press
• Always ______ the wood to the table of this machine.– Clamp
• This machine can be used to ______ or _____ wood.– Drill or Sand
Drill Press
• Always remove the _______ after tightening or loosening the jaws.– Chuck Key
• Always keep hair, loose jewelry, and loose clothes away from what part of the machine above.– Chuck