Upload
oscar-arthur-koepke
View
121
Download
2
Embed Size (px)
DESCRIPTION
Atari Flashback2 Mod Part1
Citation preview
Hacking the Atari Flashback 2
(Cartridge Port Mod)
First thing is to remove the 5 philips head screws from underneath the console. 2 of them are
underneath labels. One is the Warranty Warning tamper label, the second is in the center of the
product ID label.
31/5/2010 Hacking the Atari Flashback 2 - Cartri…
atarimuseum.com/fb2hacks/page1.htm 1/4
After you lift off the top half of the console case you can now see inside of the console and the
PCB board. The Main Board is held in place by 6 screws, the Difficult Switches board is held
in place by 2 screws and the Power Switch board is held in place by 2 screws. Lastly the AV
cable is held in place under a tension retainer stalk with 1 screw and washer.
31/5/2010 Hacking the Atari Flashback 2 - Cartri…
atarimuseum.com/fb2hacks/page1.htm 2/4
To assist in your Cartridge Mod additional to the console, a legend was silk-screened onto the
board for easy reference. You will move a jumper wire from the IC2 ROM chip to the other side
of the C4 pin. On J3 you'll need to close the jumper - you will have a choice here on whether
you want to make it permanent or not, this will be discussed more later.
Remove ALL of the screws and carefully slide the board towards the front of the console and
then angle it up and out out of its place. Note that the Power and Difficulty Switches all have
springs between the plastic button caps and the boards, so they may spring out, keep a close
eye on all three (3) of them.
31/5/2010 Hacking the Atari Flashback 2 - Cartri…
atarimuseum.com/fb2hacks/page1.htm 3/4
So here is the Inside View of the Flashback 2 console with the PCB now removed as well as all
of the switch buttons and springs.
NEXT PAGE...
31/5/2010 Hacking the Atari Flashback 2 - Cartri…
atarimuseum.com/fb2hacks/page1.htm 4/4